UPGRADED Night sights are fragile and must be handled carefully.This tool is designed to push out the old sights and push the new ones into place. It also works good at the range for adjusting the sights side to side.To compensate for sloppy tolerances in the dovetail cuts most manufacturers machine their sights a little large and you will need to fit the sights by filing or stoning. 1. Look at the sight and see if you need the angled side or the straight side of the pusher block. Make sure the gun is unloaded. 2. Remove slide from pistol. 3. Clean gun 4. Use oil or gun grease on the threads of the tool and oil the sight so it moves easily. 5. Install the slide and shim as needed with spacers or washers so you`re lined up to push at the bottom of the sight 6. Put slide into tool. Use the included spacers to adjust for proper fit for your specific handgun. You can use them anyway you wish to make it fit correctly. Place side spacer TOWARDS handle as in pictures. 7. Check that you have it lined up right. You might want to put a something to protect your gun in-between he gun and tool. 8. Slowly turn the bolt head and keep checking as the sight moves into alignment. (20 pounds of torque on a 6" long wrench is over 2,000 lbs of pressure pushing on the sight.) 9. DO NOT force it " STOP " and soak the slide and sight in gun oil over night and then try again to get it apart. Some stock sights so tightly fitted that you should consider taking it to a gunsmith for proper fit We accept no responsibility for the use OR misuse of this device. Any damage to the item or the firearm are the sole responsibility of the buyer. Again, please do not force your new sight on. If it is very tight it will need to be oiled. Tool for most Glock pistols
Trustpilot
1 week ago
1 month ago