48-84-009 Recessed LED Taillight #84 - Tripe w/ Backup

These were pretty easy to install. There are no instructions except wire descriptions on the back of them. I recommend taking off the original tail light wires at the same time as reattaching the new ones. I used the original wire clips and covers.I was so surprised at the brightness of these lights. They replaced 22year old bargman tail lights on my RV. The white reverse light completely light up the rear view so I can see in the dark on the back up cam.Blinker flashes very quick which is something I am not super fond of, but I think it will be a good thing when traveling at dusk or dark.You will not be disappointed with these tail lights.

I had to perform a little trimming on my motorhome to install these, but once that was done, installation was straightforward. The lights are very bright and are a nice upgrade to the motorhome. I didn't need to add the load resistor for my blinkers as some have suggested - blinkers still blink at same rate as before. Changing light bulbs or lenses will be a breeze in the future because the rear housing will remain on the camper. On the OEM lights, I had to remove the entire lens assembly and recaulk/dicor every time that a light had to be replaced and the lens just looked ugly. These lights are a huge improvement.

I wanted LED tail lights on our motorhome. They are far superior for their visibility during the day and the nightime. They also draw less voltage to operate than the old bulb style tail lights. They are relatively easy to install. The only criticism I see is there should be a rubber gasket incorporated into the edges of the unit. I used a good brand of clear caulk to seal them up. All in all, I am happy with the purchase.

This product installed very easy. Didn't come with instructions but the light does have a schematic on the back to tell you what wires do what. The reverse lights are still stock Halogen which I wish the whole light was all LED but looks to be easy to just swap it to an LED bulb. These lights are super bright. I don't have to worry about people not seeing my faded halogen power robbing junk lights anymore. When my blinker is on THEY KNOW. I would have given 5 stars in all categories IF the reverse lights were LED and had new stainless hardware to replace my old junk.

Easy install. Perfect led upgrade for my 2003 29’ holiday rambler atlantis.

We have 2007 Four Winds 5000 ... in NY I need vehicle inspection 1 per year ... this past year service tech said nope RV would not pass inspection due to original brake/TS lights not functioning ... yikes!!! I could have gone over to RV dealer with RV & had them do light pkg replace (w/Bragman no less) ... hmm they'd have to see RV -- order replacement light(s) -- do replacements into at a later date -- ouch!!!I ordered two(2) light modules ... Bragman modules were not exact fit into RV ... I had to Rotozip oscillating cutter make four(4) corner cuts to get new Bragman modules to fit ... I called service tech back to finish inspection ... asked him to do module rewiring to make sure it worked 100% ... tech charged me extra 3/4 of hour to install new module ... tech said he would have had to do "cut-outs" ... likely would have cost an extra hour of labor per module ... Bragman light are amazing & sweet ... LED lights last forever!!!

Lights were shipped securely in its box (in pics above), install is a breeze just replacing the original lights on my fifth wheel. Brightness wise I do wish the running light portion on the lights were a little brighter, but the brake lights do light up great! It’s definitely an upgrade on my camper and looks great! No problems with the lights themselves at all. Time will tell on how they hold up!

The nice thing about these are is you can move the lights and different sequences reversed I can go in the center to the left, however reverse light leaks water inside