Grey Pneumatic (910MG) 1/4" Drive x 10mm Magnetic Standard Socket

Has been a great help in removing hard to access nuts and bolts when on the job as a powersports technician. I trust it's magnet to hold hardware firmly and keep it from falling into the engine, or into muddy messes inside atv skid plates. An indispensable time saver, wouldn't work without one. It comes in very handy putting skid plates on four wheelers as the magnet frees up one hand from holding the bolt into the socket, and you can hold the skid plate in place. I've used this weekly for months and it's held up fine. Looking at purchasing full set soon.

Had I dropped a screw, there's almost no chance I'd be able to retrieve it without having to get beneath my car and possibly remove significant pieces to get to it. It's expensive for a socket, but worth its weight in gold if you know what's at stake should the worst happen.

These sockets are great. I actually purchased the complete set, but due to losing my 10mm several times, I purchased three spares. The magnets work very well. I would advise to invest in a locking extension to hold them in place. Otherwise, they have a tendency to stay attached to the bolt or nut you are working with.

awesome product

I have been using this brand for years. I have been really satisfied with the quality over the last 15 years. No need to be the high end stuff.

I have the whole 1/4 set and had to buy this as a replacement because I dropped it. I have had the set for about 6 years and they are arguably one of the best purchases I made. The only downside to these is some of the larger sizes tend to work a little to well.

It's a nice socket and did the job I asked it to do. I bought it for a particular job (remove some intake manifold nuts), so I don't use it all that much, but it worked as I expected. The only thing I would change is to make it a bit deeper. For some bolts, I would first have to use a normal socket, then switch to this. I understand that if it's to deep it won't grab the nut, but if you put a little spring behind it, it would work a bit better.

It's a great socket, I've gone through several of them. It's cheap enough that I can call looking for it quits after about 10 minutes, and it doesn't hurt the wallet too bad