Newsmarts 4pcs Window Molding Trim for Honda CR-V/CRV 2007-2011,Chrome Outer Door Weatherstrip Window Seal Belt,Replace#72410-SWA-A01 72450-SWA-A01 72910-SWA-A01 72950-SWA-A01

The product arrived in super condition. An Amazon box on the outside, an inner box and then a very sturdy round cardboard tube which protected the contents. The installation of the product was simple although the some rubber on a couple of strips needed to be trimmed to properly fit when installed on the door. Look carefully as to where the strip will lay in relation to the metal frame for the rear roll down window and back fixed window. Mine need a slight trim with an xacto knife to allow the seal to lay flat on the door edge. Other than that minor trimming the strips fit well and look great.

These are fantastic and fit just as well as OEM. I had received one of them with 3 dents in them. I contacted the seller about it and was promptly sent a whole new set and just needed to send back the damaged ones. It takes some effort to get the old ones out but these new ones installed easily and look great.

Very nice product, fit and finish was excellent and a substantial savings over OEM. Would absolutely purchase again.

The original weatherstripping was cracking and falling apart. I purchased this weatherstripping kit along with some plastic pry tools (sold separately). I used the plastic tools to remove the original weatherstripping. This was the most time consuming part of the process. After I cleaned the area I put this in. Very easy to install - just push into place until you hear the click. It's a huge improvement cosmetically and will also help keep water from getting into the doors.

Youtube how to remove the windows seals as it can be a little hard to get them out. You need to remove the mirror and open the door a little to get them out. Once you have the old ones out the new ones pop in really easy. No instructions so YouTube away to figure it out.

The two rear moldings did not have the required angle to make them flush against the windows so it will not seal against rain/water. The retaining clips would not lock in and stay; they keep popping out. When rolling up the windows the moldings start to rise up too! Packaging had labels in Chinese and possibly very old inventory (July 2019?)

First off, these fit perfectly and were a helluva lot cheaper than the OEM ones. I watched a couple of helpful videos on Youtube for the installation, including one that showed how to remove the two side mirrors, a necessary step.I already had a trim tool kit. I wound up using about 3 different tools because the black tar/adhesive that was underneath the original pieces got over everything. WD40 worked great for cleaning everything up.The trim pieces arrived in a large mailing tube, that was inserted into a rectangular carton, which was then inside an Amazon shipping carton. Everything arrived in one piece, nothing broken, and no missing clips.As others have mentioned, there's no labeling on the individual bags to tell you which piece goes where. The two shorter pieces are for the rear doors. Once you remove one, you just need to visually align the black end clips with their proper place on the door and you'll quickly figure out which is which.When removing the rearview mirrors, it's helpful to have an extra someone to hold the mirror out of the way so that you don't need to disconnect any wiring. Other than that, the front ones go on just as easy as the rear ones.I'm so happy not to be looking at the crumbling rubber on the old trim pieces. This is definitely an inexpensive fix for an unsightly issue.

Good