Description
- UN-12000R STEAM GENERATOR SET INCLUDES: - 12KW 240V UNISTEAM STEAM GENERATOR; - TT-SERIES OUTER DIGITAL CONTROLLER; - STEAM HEAD WITH AROMA OIL RESERVOIR; - MANUAL DRAIN VALVE; - SAFETY PRESSURE RELIEF VALVE; - THERMOSTAT; - CONTROLLER & THERMOSTAT CONNECTION WIRES; - INSTALLATION AND OPERATION GUIDE.
- UN-12000R STEAM GENERATOR SPECIFICATION: ADJUSTED (!) ROOM VOLUME* 450 Cu.Ft./ TT-SERIES OUTER DIGITAL CONTROLLER / SELF-DIAGNOSTIC SYSTEM SUPPORT / AUTO FILLING SUPPORT / AUTO WATER SUPPLEMENTING SUPPORT / NO AUTO DRAIN FUNCTION / BRASS WATER INLET ELECTROMAGNETIC VALVE / MANUAL WATER DRAIN VALVE / 220~240V SINGLE PHASE INPUT POWER / 6 TEFLON HEATING ELEMENTS BY 2KW EACH / 14.3 QUARTS STAINLESS STEEL WATER TANK / 16 Ft CONTROLLER CONNECTION WIRE / 10 Ft. THERMOSTAT CONNECTION WIRE (ft) / CONTROLLER DIMENSION (inch) - 4½×7×1 / UNIT DIMENSION (inch) - 19¾×20½×8
- AUTO FUNCTIONS:- AUTO FILLING: electromagnetic inlet valve will open automatically once the system is started and fill in with water automatically until the water level reaches the maximum level. If the water level is still lower than the minimum required level 10 minutes after the start, it indicates faults of the water supply system, so all heating elements will turn off automatically.// AUTO WATER SUPPLEMENTING: if the water level is lower than the required level during operation, auto water supplementing function will be ON and will open the inlet valve. Once the water level reaches the required level, auto water supplementing function turns OFF automatically. If water level is lower than the required level 3 minute after the water supplementing order is given, it indicates faults of the water supply system, all heating elements will turn off.
- TT-SERIES OUTER DIGITAL CONTROLLER: TEMPERATURE: The LCD will display the temperature measured by the temperature sensor in the range of 43F~140F (6°C-60°C).//. The default setting time is 45 minutes. // HEATING: During heating-up process, LED beside “START” button is ON. // HEAT PRESERVATION FUNCTION: During heating-preservation process, LED beside “STOP” button is ON.// TEMPERATURE SETTING INDICATOR: When setting the temperature, the LED button is ON.// POWER INDICATOR: When the system is switched ON, the LED at the bottom of the panel is ON.// 45 MIN. TIME RANGE. // 95~131F TEMPERATURE CONTROLLING RANGE.
- Generator Sizing: Multiply the Length _____ x Width _____ x Height _____ = Room Volume // Adjustments to Room Volume: For Ceramic Tile mortar bed or cement board backing multiplied by 1.2 / For Cast iron tub multiplied by 1.2 / For Each glass block wall or exterior wall ( if freezing is possible) multiplied by 1.1 / Natural stone tiles* up to 1/2" is multiplied by 2.00 / Natural stone slabs over 1/2" is multiplied by 2.25. // Add all figures above to obtain the Total Room Volume required = Total Adjusted Room Volume.
Full description not available
