Question 1

I installed this on my 125 coolster and at dead stop full throttle it dies out sometimes . Does anyone know why?

Accepted Answer

Your fuel mixture is way to rich this carb needs serious tuning out of the box to operate correctly this is not a real minkuni carb as advertised it is a knock off just slightly better than the jink your probably removed. To solve this problem follow these 
steps.  Step1) remove your spark plug after warm up and 10 min run time if it is black at all continue to step 2) order a jet kit ranging from 80-115 step 3) remove the carb and bowl to access the main jet it will more than likely be a 115. Step 4) remove and replace main jet with a progressively smaller jet repeating steps 1,3,4 until you have no carbon on your spark plug ( either completely clean your plug each time or buy a pack to change them always start with a clean plug per jet change) step 5) once your plug is now running clean adjust your needle drop by moving your clip up or down on the notches to get a clean throttle response with no gasp or over rev ( to lean and rpm will seem to last after throttle release to rich it will gasp like it's taking a deep breath before rpm rise ) watch your plug closely during needle adjustment to lean will kill your engine. 6) turn your idle screw in until you reach a high idle and note the position now turn your needle out until the engine acts like it wants to die about halfway in between is where you want your idle to sit 7)have fun with your newly tuned carb. ( Tuning is about patience you will need to disassemble and assemble your carb a few times in order to find the perfect tune for your altitude you can speed up the main jet dialing bye decreasing the main jet size by 10 each time remember to watch your plug. I hope this helps enjoy.

Question 2

Bought carb now bike wont idle without choke. What do i do

Accepted Answer

Adjust the air fuel mixture screw on the bottom. In for higher idle and out for lower. Sounds like it needs to goin a full turn or two.

Question 3

Will this fit an SSR razkull 125?

Accepted Answer

★ Fits 110cc 125cc 140cc Lifan YX Zongshen Pit Dirt Bikes,Fits XR50 CRF70 KLX BBR Apollo Thumpstar Braaap Atomic DHZ SSR Engines.
★ Engine side: inner diameter is 26mm,outer diameter is 48mm,Air filter side: inner diameter is 34mm,outer diameter is 39mm

Question 4

my Choke does nothing when I move the lever, is this normal? I just took the carb out of the box

Accepted Answer

Hello, normal, you try to install again.

ASIN	B07NW7CMVQ
Best Sellers Rank	#36,887 in Automotive ( See Top 100 in Automotive ) #81 in Powersports Carburetors
Brand Name	LIYYOO
Compatible with Vehicle Type	Motorcycle
Customer Reviews	4.2 4.2 out of 5 stars (1,209)
Exterior Finish	Zinc
Flange Type	Bolt On
Item Dimensions D x W x H	3"D x 4"W x 8"H
Manufacturer	Mikuni OEM
Manufacturer Part Number	OEM-VM22
Model Number	VM22 Carburetor
Recommended Uses For Product	Motorcycle
Specific Uses For Product	Increased Power,Performance

VM22 26m Carburetor with Air Filter Intake Compatible with Pipe Pit Dirt Bike Motorcycle 110cc 125cc 140cc Lifan YX Zongshen Pit Dirt Bike CRF70 XR50 KLX BBR Apollo Thumpstar Braaap Atomic DHZ SSR

Details

Details

Description

Specifications

Common Questions