JX Servo PDI-HV2060MG 62KG Metal Gear High Torque High Voltage Core Digital Servo Motor for 1/5 RC Car Robot Arm Helicopter Airplane Parts

Works awesome on my Kraton 8s. It is better in every way compared to the stock spektrum servo. On 7.4v esc setting this servo is a total beast after months of bigs jumps and hard crashes. I will be buying another when it finally wears out one day. FYI the 5th scale servo mount from Arrma is also needed to complete install.

This thing is way better than the stock spektrum servo you get in the Arrma kraton 8s, just make sure you buy the Arrma receiver box to use this servo because it's bigger than the stock servo, great quality, really strong and fast highly recommend.

Put this in my Outcast 8s and it does the job great! Way better than the PowerHD 80 kg I had in it. More power and waaay faster!

I bought this to replace the stock servo in my DBXL-E and the stock servo horn wouldn't fit, even though it's also 15T spline; this is 15T spline but somehow just a tad bigger. So if you use the horns that come with it, you're ok. If you use another 15T horn, it probably won't fit.

Bought it in 2020 but didn't put it on immediately as I was called out of town without notice. A few weeks after getting back I put it in and wouldn't even power on. Tried it on 3 different trucks just to be sure.Followed up so I could simply swap it with a new one( becus accidents do happen) and never got a response. I was so angry I didn't reach out to Amazon right away but when I did it was too late to do anything.Never left a review until now because I forgot all about it until now. I'm looking for another one for my other kraton and ran across it so I figured I'd leave my 2 cents.However don't be too discouraged, I've heard plenty good things about the servo. The SERVice, not so much. I just won't buy another one. 😕

Put this to use in a duo for two axis robot tilt. No issues so far, they seem to handle the task well. No PWM noise despite operating at a 500 Hz cycle.

The first JX servo I received had stripped out case screws that deemed the servo unusable. The replacement works great and is holding up to 8.4v in my K8S

I used this item in one of my 5scale 2 stroke trucks..lots of torque..but I keep it real..even with the end points set just are this servo heats up.