SNS 1/4"NPT DC24V Brass Electric Solenoid Valve Normally Closed Water, Air, Diesel 2W025-N08/DC24V

Well built, easy to install. We used this to replace a failed solenoid on our boats air horn system. Works as promised, looks like it will last for years.

I used two of these units as priming circuits for my two shallow well pumps. They fire for the first 30 seconds when the pump is called for in order to guarantee the pumps operation.

Good solenoid. Bpigjt the pladtic one and hsd to return it. All these solenoids are ment for short duty or they will heat up and seize. I ended running this at 7.5 volts and it worked, still got hot, but never stopped working.

Running one per bag on my airbag setup, they go up just as fast as my 1/2 valves go down, very pleased they have lasted over 6 months with zero issues.

I have used these 4 times to release compression on an internal combustion engine. They work great for that application. But the last time I mounted the valve too close to the exhaust manifold and it melted the internal bonding and the coil fell off. To properly there must be at least 4 inches away from the exhaust port and coupled with 1/4 inch compression fittings and copper tubing.

I had bought this solenoid to replace the 10 yr old one I had that finally gave out. Though the brand is different the solenoid is the same and it worked flawlessly from the beginning. Install took me less time then wiring it and fit perfectly where it needed to go. Actuation was fast and there were no air leaks from it.

Worked.

This is an outstanding solenoid valve. I am using it on an air horn on a vehicle. Far superior than the chrome-plated junk.

FUNCIONAN MUY BIEN Y EL TIEMPO DE ENTREGA ME PARECE PERFECTO

Exceptional performance as it related to my particular project. Easy to install and wiring/materials of acceptable nature. I'd certain purchase this again if in need.

Used this as a replacement on my millermatic 200 mig welder, works as it should.

I've only just started using it but it seems to be working fine. I'm using it to control a sprayer nozzle for my garden hose. The on time is only about 5 seconds at a time, so overheating isn't a problem. It seems to be drawing about 1.2A current under household water pressure load. It does operate right-side-up as in the instructions but also seems to work fine on its side. I haven't tried it in other orientations. It does restrict the water flow far more than I was expecting, but it's not a problem for my purposes.

It looks like it will replace the auto fill solenoid on my polar bear water distiller, for a fraction of the cost.