Universal Aluminum Jack Pad Jacking Puck Point Adapter Support Compatible with Tesla Model X Model S - Protects Battery, Side Skirts, Frame Rail (Qty 1, Black)

Solid and stable to use, and fit perfectly in the Tesla Plaid Model S. No complaints.

These are the second set of lifting pucks I bought for the 2023 Tesla Model Y. The first set were made of rubber and were too big to fit in the whole under the car. These are too loose but at least they do fit in the holes. The O ring serves no purpose. Buyer beware.

My housemate, who actually used the puck, said I should leave a good review, so I'm doing that. She said it worked quite well. 2017 Model S.

I was hoping these would fit but to no avail. If you have a 2023 Model Y built in Austin with 279 miles of range these won’t fit the hole. I double-checked to make sure they sent me the one with the 20mm notch and it won’t fit. I’ve been searching for one that fits and have yet to find one.

I use this one for use with my bottle jack. I use the poly pads for use with my floor jack. Once I have raised the car enough to clear the bottle jack I use the aluminum one as a safety (in addition to the floor jack. I think it puts less stress on the frame and provides more stability when torquing the lugs on a Tesla. EVs have huge torque value on lugs because of the high torque during accelerations.

Sturdy pucks that provide enough clearance so my jack is not in danger of touching car body. Got 2 of these to lift one side of the car at a time for tire rotations (using two jacks)

Fit perfectly on my 2020 Performance Model X. I only wish it came with a container to hold a set of four as I've seen some others provide. I just threw them in my mobile charging connector bag.

Tried this on my 2022 Model S. It fell out unlike the other pad I had. Post diameter with o-ring was the same. The difference was this units o-ring groove is too close to the top of the pad surface. So the o-ring didn't get up into the hole far enough to grab. If you look at some of the other pads available you'll notice the o-ring position. I returned this and will get something else metal like I had before.

Puck won’t stay on frame it’s to small and falls out

The jack pad insert tube is too small and falls out of the Tesla Model 3. The pad drops out and does not stay secure in any way to the Model 3. Not a correct design size for the Tesla Model 3. Will request a refund. Not recommended

J’aurais pensé que la rondelle de caoutchouc rouge servait à maintenir l’article en place sous la voiture le temps d’ajuster le cric. Au contraire il faut viser juste dans l’orifice prévu alors qu’on monte le cric.Vraiment décevant, une bonne vieille rondelle de hockey sera plus pratique.

The media could not be loaded.  Adapter does not hold up from the jack point. The rubber O-ring is literally useless. As seen in the video, it doesn't stay in place. I have other adapters that stick to the underbody and fits snugly with the O-ring but this one is very loose. Makes jacking up more difficult.

Having the pad with a 'dowel' on it give me a bit more confidence on when jacking up the Tesla. The other ones on Amazon have a thing plastic washer so there's no direct metal to metal contact but I don't think its an issue since the surface on the pad and jacking points are smooth. Good value.