Biantie La 2-Pin 8mm LED Connectors Solderless Unwired Clips - DIY Strip to Wire Quick Connection for 12v 24v Single Color SMD 3528 2835 Tape Lights (Pack of 10)

These are not bad. 20 gauge wire works best. I use these in conjunction with 8mm aluminum channel for under cabinet lights. I've been clipping off the tabs so I can fit them neatly inside the channel and cover them up with the plastic diffuser that comes with. I also have been trimming where the LED tape inserts as I use high output LEDs and the diode is very close to the solder connection. I haven't had any fail and I will continue to purchase as these are the only wire to tape connectors I've found.

haven't used any of them yet but they look good and they look solid

I thought this would be a quick way to avoid soldering for my LED project, and it was handy, but I ended up doing a little soldering anyway because it doesn’t handle stranded wire too well. Inserting bare stranded wire almost always ended with a few stray strands that had me worried about short circuits. I ended up tinning the wire to avoid stray strands bridging the gap, but otherwise it’s been functional.

The connectors work perfect to finish up my project.

My first install in my house I soldered everything together. While this is a fine solution and doesn't take that long- it does make install trickier either pulling wire/ lights already connected, or.. soldering once in place. With these it's pretty simple to get all your wires in place and connect them up. Everything felt pretty secure but I still wrapped some electrical tape around it to keep it even more snug and in place. Pro tip: If you put everything in place and THEN connect everything- leave 1/4" inch or so of the backing to the 3m adhesive on the lights so you can still slide it in the connector. If the backing is removed it's near impossible to put in place. I discovered this when trying to add a section after the fact because I wanted more light. Still got it done, but it wasn't near as easy had I just left a little bit of the backing for future extensions if needed.

I bought these connectors with the LED strip lights. No instructions to the connectors but trial and error. I measured all my lights and wire. Put it all together, it worked for a minute then all lights went out after I tried to attach to my upper cabinets. What a waste of time. The wire that was recommended was just too thin to use. So instead of tossing all into the trash, I ordered a new soldering iron to solder all the connections.

These lights are easy to use, Just know exactly where you are going to put them, because once you peel the backing strip off, they are Super Sticky, and difficult to keep in a straight line. They are Very Bright and you can turn them down to almost no light at All

These make it so quick and easy to install strip lights in a variety of places and lengths. Must have! Order extras cause once you see how they work you will want to use more putting lights everywhere!