Rigid Spout Replacement and Vent Kit

High grade plastic. Fit my current gas can beautifully. Works like a champ. So much nicer than the original corrugated flimsy spout. Very pleased with my purchase.

This fit my gas can perfectly!! I have been looking for a spout for a while now but didn't want one of those stupid safety spouts. I seem to have all kind of problems with safety spouts and always spill some gas but this spout worked great! I didn't spill a drop...Love It....10 STARS

Well made. Could not use one of the caps on my older gas can but the spout worked with my gas cap. I drilled out the vent holes, and the vents appeared to fit well. Have not filled yet to see if anything leaks. Like the fact they have built in filter at the base of the spouts, and the size of the spouts. Glad to finally get rid of the old safety spout on one of the containers that was a total pain to use.

Works well. Does not Leak a drop. Easy to use.

Great replacement for the old nozzles on cans that predate the “safety” nozzles that the government afflicted us with. It pours smoothly and doesn’t leak. Very happy with it.

Anyone who has tried to pour gasoline or diesel out of a modern spout has wondered why the new spouts dribble and are hard to handle. The answer is...the federal rules governing fuel cans were apparently written by the same lot who brought us 'child-resistant' medicine bottles. The EZ-Pour rigid spout works around all that gumph. One selects the right ring for the can one is using, tightens it over the spout, and pours away. When finished, one screws the small yellow cap in place on the end of the spout. However, store the can out of direct sun, since heat can and will blow up a plastic can like a balloon if one does not install the provided vent cap. This is not a bug, buta testimony to how well the spout seals the can. Have bought before; will likely buy in the future.

Good quality, well made. Some other brands use a cheap quality of plastic that does not hold up to gasoline and fumes and cracks and splits. This one is good.

If you have a little common sense you can ditch the stock spout included with the your gas can and install these. I installed my first EZ-POUR about 10 years ago and the plastic has held up just fine. But the stock spout that came with another can got brittle and cracked so I got an EZ-POUR to replace it. The included EZ-POUR yellow collar screwed onto my Midwest can just fine, but I re-used the Midwest black collar and the EZ-POUR nozzle fit and sealed just fine. Do not skip installing the yellow vent that EZ-POUR includes, it is needed to allow air to enter as the gas pours into your mower. EZ-POUR has vague instructions on the packaging which don't really mention how or where to install the vent, but it's easy to do. Just drill a 1/2" hole on a fairly flat spot behind the handle of your can. This will keep the vent above the liquid when can is full and resting on floor, and it will also keep it above the liquid when the spout is pointing down filling your mower. The vent will not be easy to push it into the 1/2" hole because it is intended to be a tight fit in order to make a good seal. So put the cap on the vent and drive it in with a rubber mallet, or place a block of wood block over it and lightly tap it in with a hammer.

Good product! Love it

The only problem was that the supplied collars for attaching to the jug could not be used. The original one on the jug works best.