Motip Heat Resistant Spray Paint - Red - 400 ml

It was the right colour

The material I sprayed hasn't burst into flames yet so it must be working.

I use this paint as a primer on brake calipers. Heat the can for 10-15 minutes in hot water, give it a good shake and you're ready to coat. You'll see from the images attached that the finish is consistent and well adhered... perfect for a colour and gloss lacquer.The reason I've dropped this one star is because I also bought a can of Black. Again same good coverage and same result from the can but this was applied on top of the Grey as a colour coat. However the finish was a Satin Black and I wanted Gloss. I added a Gloss coat using ETech VHT Gloss but it reacted. So I re-prepped and repainted but this time I used the same MOTIP Heat Resistant Spray Paint Gloss. Luckily I tried this on a piece of spare metalwork I had lying around. It reacted again! Such as shame but I've now had to reside to having Satin Black calipers.Have already purchased more cans of the Grey for some Engine parts..

Very good

I waited to review this as I used it in summer when I could have the radiators off. I bought the anthracite one. It has stayed looking great throughout the winter with constant use. My rad is 2100 x 300 and was roughly the right amount in the can with several passes on the front and all the visible white on the back.

Gets blocked within a few seconds of use. Totally miserable can, unfortunately won't be touching Motip products again.Happened to 2 spray cans, you'd think they would have dealt with the issue and design better nozzles that don't get blocked so easily. In the end I had to use a heated pin to enlarge the hole to then get the contents out of the can and ended up using a brush to get a somewhat ok finish.Should have just returned them, but needed them for the job in hand and had to make-do with some DIY nonsense just to be able to do what the can should have done in the first place.Spray can shaken for well into 4 minutes, temperature was around 24 degrees on the day. Unfortunately this isn't a 'user-issue', simply a bad spray nozzle for the kind of content this can holds.Don't recommend this brand at all, will make you pull your hair out and leave a royal mess behind at that too.

Poor quality

Perfect.I used it on the fire board around my log burner. I had gold leafed it and needed a seal to protect it.It's perfect. It doesn't spray too far. Easy to apply. Smooth finish. It's held up really well against the heat