MOOGK90460 Strut Bellows

Great quality product, as usual from MOOG. A little tricky installing the white bumper into the bellow, but take it slow, it will fit and makes me believe it should last. It’s a tight fit for the bumper to go inside the cup on the strut mounting plate. I lightly shaved a thin layer off 1/4” from the end of the bumper with a wire wheel, to allow the bumper to begin to fit as you tighten down the strut nut. As I said, these should last.

Easy fitment and installation. Fit well on the new Bilstein struts I installed replacing Monroe struts.

The bellow is wide enough that it makes contact with the spring, although it hasn't made any noise so far. The bottom of the boot is also fairly loose around the strut, so I'm not sure how much dust this will keep out long-term. I would have preferred a softer rubber bellow, but this is probably sufficient. The bumper does not come installed into the bellow, and it took a minute or two to get each one installed correctly. It appears to work well so far.

Sits on top of plastic ring

I haven't installed it yet. Local Auto Supply stores do not stock. I will keep it for when I replace a strut. I have purchased this item before and it works great

Is working good, However I had to use a belt sander to sand down the bump stop to fit into a 2004 audi a4 1.8t. Had everything out and HAD to make it work, No time for return or exchange.Just a heads up, wasnt a direct fit for me or the car I was working on (which was factory.)

Perfect fit. Easy to install along with the strut insert. Good quality. I rebuilt the front end on my 73 super beetle and it drives like new. I have trusted Moog products for years and will continue to do so.

The Moog site clearly lists mercedes w211 as a covered model for this part number. The I.D. of the bump stop is way larger than the shaft of an O.E. strut and it just flops around. Within a week of driving, repeated off center contact on the upper strut mount cut the bump stops all to pieces. I purchased O.E. bump stops with boots and they fit correctly.

it also fit for nissan sentra.thanks again.

Les soufflets sont en plastique contrairement aux originaux qui étaient en caoutchouc.

The quality looks to be OK but the bellows does not fit inside the Jeep Liberty front springs.

Crack apres meme pas 6 mois