55001 Lubrimatic Fluid Quart Pump, Fits Standard Quart Bottles

Works well

This little pump worked great for changing the rear differential fluid in my Honda CR-V! The top fit right on the bottle and had no leaks. The length of tubing was adequate, and even convenient given I was doing the job on the floor, but I could see it being a little short under other circumstances. It felt like it took a lot of pumps to move a quart of fluid, but I wasn't in the most ergonomic position either. Overall definitely a worthwhile purchase though!

Useful pump that works. The tubing is a little cheap and binds if you aren't careful, but overall it worked well. The tubing could be replaced if necessary. I would recommend this product.

Works great

Works good. I used it to pump automatic trans fluid into a transmission.

I bought this with the intention of filling my transmission fluid after I dropped the pan and changed the filter on my 2011 F-150, which uses Motorcraft Mercon LV. This was my first experience doing this sort of thing; never used one of these before. I had no trouble fitting this pump onto the Mercon LV quart bottle. Even with fitment issues, the pump will still work without a proper seal, which is a good thing because the best way to clean it after use is by sticking the straw into a bucket of water and pumping the water through it. Something to note is the photo is NOT accurate. The bottom portion of the pump is not flexible tubing, it's a solid straight straw which is roughly 6" in length. The straight straw worked perfectly fine, after tilting the bottle a few ways while pumping I was able to remove all but 1/2 tablespoon of fluid. I ended up adding too much transmission fluid and had to take some out, this pump worked great for that too. It did require 3/8" tubing to be added to the straw end, which is just a tad larger than the tubing that is on the out spout. It took me roughly 4 minutes to pump out the entire quart, but I didn't have the truck raised, was laying half way under it and had to pump the bottle with my arms over and behind my head with minimal room to work with. I imagine if you had proper room to work, or better yet a lift, it would take less than 2 minutes per quart. I found the tubing to be adequate in length, roughly 17" inches; if anything it was a little too long for what I was doing, but again the truck wasn't raised. It's easy enough to unclasp the tubing and add a longer or shorter piece if needed. The one thing I found slightly frustrating, there is no way to release the suction in order to empty the fluid in the tube. This isn't a big deal if you plan to empty the entire quart because as you begin to pump air the tube begins to empty. It can get messy if you need to check the fluid level part way through a quart bottle. What worked for me was raising the tubing as high as I could to gain a few inches of empty space in the tube, then I wedged the tube between the trans lines which held it in an upright position. When it was all said and done, I'd lost about 1 tablespoon of fluid between drips on the pan, ground and my hand.

Light, cheap...very little volume per pump.

Good working oil pump

excellent

Worked well for pumpin in transfer case fluid

Facilita mucho el trabajo, funciona sin inconvenientes

Good

Too small for automobile use. Only 4 cc displacement. Firs very small containers.