12V Waterproof Push-Button On-Off Switch with Quick Connector for LED Accent Lighting on Motorcycles, Cars, Trucks, ATVs, Golf Carts, etc

Price was great, order shipped complete very quickly. I sought a low-profile switch that I could conceal under a heat shield on my motorcycle, in a spot where I could easily access while seated on the bike. This switch is perfect in every way. The power rating is well within my needs and it is a simple press on, press off configuration. Since the motorcycle is frequently exposed to wet conditions it needed to be waterproof. This switch is sealed in such a way that it will not be impacted by rain or extremely wet weather conditions.It was important for me to be able to stick this on vs. screw it in given my selected placement. I prepared the mounting point by washing with soap & water, then using acetone gave it a final cleaning. Included with the switch is a two-sided die-cut adhesive pad perfectly sized for the switch. When applying I pressed hard and held for a full minute to ensure complete adhesion. I let it set over night before testing, and when I tried to gently pull it away the switch held wonderfully firm.One very nice plus is the inclusion of two solder butt connectors that can be activated by a heat gun or hair dryer. You place the wire from the switch in the connector, then the line/load wires & use the heat gun to melt the solder. Next, I used a crimper (not included) to crimp each end of the connector to seal and keep water resistant. Just to ensure the integrity of the water seal I finished with a wrap of electrical tape. This worked surprisingly well and took little time. I should mention that a pictorial instruction sheet with helpful details is in the package. I found this very easy to follow for every step of the way.The switch is used with a set of 12-volt fog lamps added to my motorcycle. Operation of the switch is simple, and it is easy to tell when the switch has been pressed far enough in to engage/disengage. I did not have to exert much pressure in use of the switch. After many uses in differing weather conditions the switch is still firmly attached and working well.I'll offer a tip in using the solder butt connectors: In my case the wires used were thin enough for me to slide the connector all of the way down one wire. I then carefully twisted the sanded bare ends of the two wires before positioning the connector to be soldered. The physical connection of the wires ensured a secure electrical connection and the solder served to permanently secure and enhance the connection.

Good fucntionality and calibre for the price point. Worked well for a partially covered boat application to keep a piece of electronics off when not needed to protect from electrical spikes.

I used this for my klr 650 auxiliary lights it's straight forward easy to install the 3M sticky is really good stuff holds strong the switch works like it's supposed to

My only complaint is they eventually stop working, usually after 1-2 years

Works great for my sprayer

I added these to control two hard-wired deck lights and they work perfectly. Have only had them in use for a few months, but it has rained really hard and so far they work well.

Good product!

Worked for under hood work lighting.

Installed to switch rear facing lights. Been there since last fall and used many times during the winter with no issue.

Great product

Easy installation and a quality product. I use it for LED aftermarket accent lighting.