Is the control panel included? Is it okay for 1 phase, 208V, 60Hz feed?

Question

Is the control panel included?  Is it okay for 1 phase, 208V, 60Hz feed?

Accepted Answer

Hello Daniel,The inside of the SaniFlo Sanicubic 2 comprises of a couple of pressure switches and a circuit board assembly, which starts and stops the unit, and of a couple of motors, which drive the stainless steel cutting blades and the pump.  The motors are sealed for life in an oil filled enclosure.  A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum.  Water and organic waste matter that enter the enclosure are reduced to slurry and are picked up by the impeller mounted beneath the motor.  The two grinders inside the SaniFlo Sanicubic 2 are engineered to operate alternately.  They each take turns handling the wastewater so that neither is more heavily used over time than the other.  However, if either pump ceases to operate, the other pump will run full-time until servicing can eliminate the problem.One of the many features of the SaniFlo Sanicubic 2, is the smart-pump operation.  A single pump is able to handle up to 50 gpm.  If the incoming rate is higher than the discharge rate, the pump automatically signals the "overload" stage.  This will activate the second pump and both pumps will operate simultaneously until the condition is alleviated.  When both pumps are in operation, the discharge rate increases roughly 80%.  In this event, a visual LED alarm on the unit will switch to red as well as the mounted audible alarm will go off.Note that the effluent pipe leading into the pump has to be installed with the required ¼" per foot gravity flow.  There must be a 10" height difference (from pump to connecting fixture) if the drain is connected to the bottom inlet.The wastewater from other sanitary fixtures is discharged into the SaniFlo Sanicubic 2 via five 1½-inch or 4" inlets, on either side of the housing and on the top of the enclosure.  The internal discharge pipes come equipped with check valves that prevent back flow into the unit.  Isolating valves (ball, gate valves) must be installed on waste inlets and on the discharge pipe to ensure that any service/maintenance may be carried out safely.This unit has been designed with a 1-1/2" vent connection on the top of the enclosure.  All plumbing codes require connection to a vent system.  Please note that the vent system should be a two-way air vent.  The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems. Thank you very much!

ASIN	B07XVZVXSD
Best Sellers Rank	#544,598 in Tools & Home Improvement ( See Top 100 in Tools & Home Improvement ) #548 in Sump Pumps
Brand Name	SANIFLO
Color	White
Customer Reviews	5.0 5.0 out of 5 stars (1)
Flow Rate	40 Gallons Per Minute
Global Trade Identification Number	00859925002992
Horsepower	1.5 Horsepower
Included Components	Heavy duty Vortex pump
Item Type Name	Heavy duty Vortex system
Item Weight	196 Pounds
Manufacturer	SANIFLO
Manufacturer Part Number	saniflo-99
Manufacturer Warranty Description	3 year warranty
Material Type	Plastic
Maximum Lifting Height	43 Feet
Model Number	099
Power Source	Battery Powered
Product Style	Duplex Vortex System - 240v
Specific Uses For Product	commercial_use
UPC	859925002992
Unit Count	1.0 Count

Sanicubic 2 VX Vortex - 240v - Commercial

Details

Details

Description

Specifications

Common Questions