2 inch 5x5.5 Wheel Spacers for 2012-2018 Ram 1500 | 4 PCS 5x139.7mm Forged Wheel Spacers with M14X1.5 Studs & 108mm Center Bore for 2012-2018 Ram 1500 2019-2024 Ram 1500 Classic

I've waited over three years to write a review for these spacers. The reason being I wanted it to be an honest review. At first I was hesitant about ANY spacer, as I read some negative reviews, but I decided to judge for myself. All the complaints about this product revolve around breakage of the included studs. I currently own two vehicles with these spacers. A Ram 1500 4x4 and a Grand cherokee 4x4. I have not experienced ANY type of failure over a three year period with these spacers. I have driven the vehicles for over 20,000 miles each at all kinds of driving condition and at times over 80mph and even off road regularly. I even installed a set on my daughter's 2002 Ram 1500 4x4 pickup. Having said that, I must say that I took great care in installing these. Cleanliness is super important. There must not be any type of debris or rust in the mating surfaces. The factory wheel studs must be rust free and the correct length and must not stick out beyond the spacer. Make sure the hub-centric spacer fits tight against the locating ring in the factory hub. inspect wheel mating surface and again make as clean as possible. After thoroughly cleaning all the surfaces, coat spacer and brake rotor mating surfaces with silicone grease, careful not to get any on the stud threads. install spacer onto brake rotor and use a straight edge to verify factory studs are not protuding. Use the provided loctite and torque to FACTORY specs for your vehicle. Install your wheels torqued to Factory specs and spin a few turns to make sure wheel and spacer are seated properly. Drive vehicle conservatively for a couple hundred miles. Remove wheels, retorque spacers and fill factory wheel stud cavities with grease. Reinstall wheel and inspect and retorque spacers at every wheel rotation interval. After the three years while doing a brake caliper change, I did find one of the studs that came with the spacers to have surface rust where the zinc plating was worn off from removing wheels for maintenance. So keep an eye on the studs for corrosion and replace if in doubt..they cheap ienough. So in conclusion, I would not hesitate to purchase these again or to recommend to anyone, though keep in mind these are not install and forget items, they involve maintenance like any other automotive part..use common sense when installing.

These were a breeze to install. Made a significant difference with my stock wheels on a 2011 ram 1500. I now have a more aggressive look/stance with the tires outside of my fenders about an inch or so. Came with everything needed. Nice that they sent the lock tight and directions. High quality build and fit. The only down side is you will need a thin wall deep well socket in order to attach the spacer to the wheel hub as there isnt much room.

Was skeptical about these at first, but I have had them on for over 700 miles and so far great. I used the red loctite on all threads and torqued to Ram specs of 130 ftlbs for the 2020 Ram Rebel. Checked them at 100 miles and 500 miles and they haven't budged. They pushed the tires out perfectly. Due recommend ordering the form fit mudflaps also or you will spread dirt down the side, I did notice a slight rub when turning hard, but not a biggy and no damage at all.

Looks great. The holes were tight fit for my sockets but I made it work with some lubricant.

Muy bueno

Studs are approximately 4mm to short (safety risk) wheel to hub will leave 3 or more threads without torque also the supplied nuts are cheap soft material (will not stand heat and vibration)a slight bang with a hammer and they will completely deform these should not be sold until issues are resolved (THEY ARE UNSAFE FOR ROAD USES) if you love your expensive truck absolutely DO NOT! Purchase these.

Great item for any 4-wheel drive owner.

Made my truck look mean

⭐️⭐️⭐️⭐️⭐️ Exactly What I Wanted These spacers are awesome! Super easy to install, fit perfectly on my Ram 1500 2024, and instantly gave it a better stance. The quality feels solid and I haven’t had a single issue since putting them on. Honestly, couldn’t be happier with the results. Pd. Make sure to use a torque wrench for safety reasons! 😁

Great product, great quality. I would recommend these for sure!