1/4 Inch Shank Slot Cutter Router Bit Set - 6 Size

Love that it has different thicknesses to make just the right slot.

Just finished using the new router bit. Did a great job and 1/4 the price of a similar bit from Lowes. Not sure how long that will last but I’ll probably loose them before then. Great savings on cost. Highly recommended

Great selection of bits. However, one of the shafts bent while routing a board on my deck. Shattered the router base flinging pieces everywhere and dug a gouge into my Trex decking.

Great variety in this pack, however I wouldn't recommend using it in hard wood. All in all it definitely works for what I need.

I used the router bit to cut through approximately 15-20 linear ft of poplar wood for a project I was building, using the 3/32 cutter. I had the bit set up in a router and router table with a proper feed going. About 7/8 through the way of cutting everything, I heard a snap, and stopped everything. I noticed a piece of metal was stuck in the wood. Upon investigating further, I noticed that 2 out of the 3 teeth on the router bit had broken off and the 3rd was about to break off. I had a similar 3/32 router bit from Rockler (that I didn't initially know I had, hence why I bought these). In the picture you can see the comparison of the cutting teeth, that the rockler teeth are quite a bit longer compared to the Meihejia bit teeth. Luckily I had this setup in a router table with a vacuum behind, but these teeth easily could have flown off and hit me. Kind of dangerous.

Recently I needed to cut some 1/4" slots in some wood and used one of the slotters that were less than the width so I could make sure I did not oversize the cut. First Issue I had was they are on a 5/16" mandrel (Router shank is 1/4" but the top part is 5/16") and they do not come with a bearing as pictured. The next issue I had, was not having a spacer long enough from the threaded end of the mandrel to the slotter . Fortunately I had a set of bearings (skateboard) with an 8MM Id and 7MM thick. I used 2 of the bearings and a washer and it worked out great. I would have given more stars, but since I had to come up with something to make it usable, and it shows it having a bearing, but does not.

This worked great for me putting slots in for TimberTech Solid Planks to use CONCEALoc® Hidden Fasteners.

Don't know about the durability yet, haven't had them very long. I use them to cut slots to make rings for pool cues. So far, I'm happy with the product and it's accuracy.

Adaptable a la medida que se necesita. Muy buena calidad.

As described, worked great for what I needed

I only wanted the 1/8" thick blade, the other sizes are just extras.I tried cutting on MDF and plywood... seems okay but I did notice it wasn't as sharp as I'd expected since it's new. While it didn't burn it didn't cut like a hot knife thru like other new router bits I had in the past.For the price and what I needed it for, it's just okay 3/5 starsUpdate Mar 30 2023.I used the 1/8 slot cutter on 2 pieces of white oak, approximately 134 inches...seem cut ok but I kept thinking the blade was going to explode any second...maybe I will use only on plywood? Hard woods might be a bit too much?

You get what you pay for. They worked, but are for light projects ,as I would have expected due to their price. Not unhappy.