Acxico 2Sets Laser Sensor Module For Arduino AVR(KY-008 Laser Transmitter +Laser Receiver Sensor Module Non-modulator Tube)

Works well and interfaced well with ardunio.

First let me say that if you just want to experiment, these work great! Don't expect an easy way to set them up though, as there are a few things to note:- Make sure not to put the sensors on backwards! Use the reference images from the listing. DON'T align the bump on the silk screen with the bump on the component!- The PCB for the sensor is one sided! This means the the pins that attach into a breadboard cannot be flipped onto the other side of the PCB. Very low quality but works. This also means new pins cannot be attached on the other side easily to change board orientation when attaching to a bread board.- With the way the pins are installed on both modules, it makes the modules point straight up/down, which is very annoying. I opted to replace the laser pins with straight pins on the opposite side of the PCBA. This makes it much easier to work on a table. The same goes for the sensor module, but at least the sensor itself has thin leads that can just be bent upwards.

These work great so far. To whom this might be of interest, they work well using 3.3v as well.

Works as supposed to. The laser mounting is a bit fragile. I forced it to align to aim and it broke after serval trys. So be gentle when

🧐

The lasers work great, but both of the sensors broke within a few uses

These are a nice laser and transmitter sensor combo. They work well and are inexpensive. I'm happy with them. There was no manual included so YouTube and online datasheets will help. Make sure you double check the polarity. Hope this helps!

I bought two packages of this product, one came with what was specified but the other one had the wrong item and I received a kind of metal rope.