GNA36i 30-Amp 3600-Watt Parallel Connection Kit for Inverter Generators, Black

Purchased this kit to go with 2 new WEN 3600 Generators I recently bought for the Travel Trailer. Went with 50 Amp kit because it has both 50 Amp and 30 Amp interfaces. Have run it in parallel mode now for 18 hours and it has been flawless showing no signs of overheating, etc. The only issue I had was that the 30 Amp Twistlock interface, when connected to a 30 amp TT-30R power cord, was technically upside down and the power cord stood straight up. I rotated the interface 180 degrees and it now works better. I also mounted it to a 6" x 4" x 12" piece of pressure treated post to get the parallel kit up off the ground when using it in a Generator tent outdoors.

Works good quality

Does what it says it does

Connected my generators and worked. Got here fast.

Haven’t used it yet but looks strong and well build enough so far. A little pricey. Will come back later after using it to combine my gens. Tks

Yet another well thought out and designed product from WEN. I bought this along with two WEN 56200i's to run the AC in my travel trailer (like so many others). While I haven't been able to use it with the AC yet, I did run a parallel test with a couple of heaters and an air compressor, just to verify that it (and both of the generators) worked properly. Yup, worked like a champ. Ran the 2 1500 watt heaters without a hiccup. Couldn't handle the additional load of the compressor, but since that is a 12 amp load, I was effectively asking the 2 generators to put out 4320 watts. They're only rated to 2000 apiece, so...As far as the design and build quality of the parallel kit, it's pretty tough to beat. It's solid, has nice connectors, and rain/dust covers for the outlets. But the best part, assuming you're using it with a WEN generator, is the clever spring/clip mechanism for attaching the parallel kit to the top of you generator (somebody has a picture of it on a Honda generator, but they don't show the back so I don't know if it's attached or just resting on top). Brilliant design, keeps it out of the way and off of the ground. And, as if that wasn't enough, it seems to be the least expensive parallel kit out there.I'm slowly developing a fondness for WEN products. They, at the least, approach the quality of the major players, at a price far, far below them (the generators are less than half the cost). Definitely worth your while.Official Seal of Approval applied.And my review of the WEN 56200i... https://www.amazon.com/gp/review/RGVOA1B0P7322?ref_=glimp_1rv_cl

It worked fine with no real issues. I had to cut the clips because my nuts didn’t come off to avoid losing them. Thats nothing against the product, just my generators. I was a little hesitant to purchase but they were the right item for my gennys. You can compare the same item for 3x the price in other spots.

Typical WEN quality. I will use these with the genmax 3 inverter parallel kit