Ambient Weather F007TH Wireless Thermo-Hygrometer for WS-07 Weather Stations

Works fine. It replaced older one that quit after a few years.

I've used this model for several years and it works well to monitor the temperature of an outdoor pool. The transmitter is rugged and can tolerate winter weather, but the thermocouple wire can be torn by ice freeze/melt cycles in the winter. To be safe, remove thermocouple wire from pool. Although the can tolerate winter, when it stops transmitting you should replace the batteries to avoid battery leaking. If you leave the dead batteries in the unit with high heat and/or cold, you run the risk of the dead batteries leaking and damaging the electronics. It is safer to remove the batteries after the swimming season ends.

I bought 4 (weather station) sensors & 2 consoles 4 years ago; sensors outside front & back of house, sensor upstairs in the bedroom & downstairs in the den; console in bedroom & den. I've changed batteries from time to time & they continue to start back up just fine. Recently when I retrieved one that wasn't transmitting, I found a battery had leaked inside, essentially killing it. So I ordered a replacement sensor. It showed 20 degrees more than it should've. I did a Return/Replace, the replacement was doing the same thing. I tried again. Update 7/10/25: Fortunately, the 3rd sensor I received shows accurate temperature & it only took a few minutes for the consoles to recognize the new sensor. The original sensors & consoles continue to work good with the exception of the sensor my leaky battery killed. Alexa can tell me the temperature outside, but I especially like knowing that my bedroom is cool enough (portable A/C & fan) before I go up to bed. It's also interesting to see the major temperature difference between the shaded one on the back deck & the one on the sunny front porch.

I liked the initial kit enough to buy another 5 transmitters to max out the units capacity to a total of 8. (each transmitter sends out both temperature and relative humidity readings). I found the transmitters to all be reasonably consistent and accurate when calibrated with a trusted thermometer and a salt chamber for verifying the RH readings. You can even fine tune each reading on the central display to compensate for any calibration errors if necessary. Mostly I wanted the transmitters to monitor the performance of a multi chambered root cellar, but I also use it for monitoring the efficiency of my HRV system for interior air quality. I live in an ICF house with a lot of concrete walls blocking the signal from the transmitter to the central display. I did finally find a location in the house that could get a signal from all the transmitters. Dont expect much more than 30 feet distance if the signal has to pass through concrete walls and floors. The transmitters work fine from inside a PVC pipe but not at all from inside a metal pipe. Note: only three transmitter displays are fixed. The fourth readout on the central display can be set to continuously scroll through the other 5 transmitters. Each transmitter takes two batteries, so factor in that cost when buying multiple extra transmitters. I think it is a pretty good value for those looking to remotely monitor multiple locations for temperature and relative humidity.

I was pleasantly surprised that these units are still sold for my base unit. On of my senders went inaccurate and this fixed it!

We bought these to use to monitor air and soil temperatures in our garden and in our rabbit barn. I was really disappointed to discover that they are only accurate within 2 degrees either way - and of course, it didn't say that anywhere in the product description. That's a significant difference when you're trying to measure what difference you are achieving in the air and soil using row covers, cold frames, and hoop tunnels. If you are comparing air temperature in the garden, and air temperature in a cold frame, and they are both off 2 degrees but in different directions, that could be as much as 4 degrees difference. Significant when some types of covers only buy you 4-6 degrees in temperature protection! We bought 8 total sensors, and allowed them all to sit right next to each other for several days before installing, and none of them registered the same temperature. So we thought about trying to make it work anyway - after all, we're just hobby gardeners, not a nursery. Our house is about 80 feet from our garden, and with just one wall or window (we tried both), we couldn't get readings from the sensors down in the garden. Granted the signal also had to go through the twin wall polycarbonate of the cold frame, so I guess that's two obstacles. What the product description also doesn't tell you is that for every obstacle that the signal has to go through, the range is effectively cut in half. So you start with a range of 300 feet, go through a wall and you're down to 150 feet (or more, depending on what the obstacle is made of). Go through another obstacle and the range cuts in half again, so you only get 75 feet. And so on... So our next move was to take the base unit down to the garden and put it inside a rubbermaid bin about 10-25 feet from the various sensors. Still two obstacles to every sensor, but almost no distance. You guessed it, it still didn't keep connection with all the sensors and you have to reset them. Added to that, you have to actually go to the main unit every day to record the min/max for each sensor, maybe not a huge deal since you need to go out to the garden regularly anyway. It is easy to reset them, but if you're recording your min/max temps every morning (for example) and you go out to find that a sensor (or five) lost the signal - you won't get an accurate range, because if it stopped the evening before you won't get a reading for how low the temp went overnight. There are other systems out there that you can buy for not much more money (watch sales). The system we bought to replace this one actually has the air and soil thermometer in each unit, so if you buy eight of those you can actually get up to 16 readings if you're using both the probe and air sensor in each unit! **Update 6/12/14 For those who marked that they don't find the review helpful, I'm sorry that you disagree with a negative review, but that's what the review system is all about! We followed all the instructions, we researched and asked questions, so we know how and why things work the way they do with these types of systems. The negative review wasn't about the temperature variation, it was about the fact that the sensors could not communicate with the base unit, even when we moved the base unit down into the garden with the sensors, so it was within 15-25 feet of each sensor with two thin barriers between each sensor. Based on the specs by the manufacturer, it should have worked, yet we had to reset more than half of the sensors each and every day, no matter what we did. Maybe we got a defective unit - we had conversations with the manufacturer were told that was just the way it was, and it wasn't defective by their definition, even though it didn't work. Bottom line, our sensors would not effectively communicate with the base unit, We bought a system from another company that basically had the same specs and same setup as this system. We set it all up, with the base unit in our house vs. having to be down in the garden, and it has been working perfectly all this time. **Update 8/12/14 Since a couple people asked what we're using - we bought our system through http://www.harrisseeds.com/storefront/s-283-thermometers-weather-stations.aspx when the sensors were on sale for $14.95 each. That model has been discontinued, but they do have some on clearance for 29.95 as of today. Ours have the label 'Weather Direct" on them, and through their website we are able to view the sensor information, set alarms, and download all the data to a spreadsheet. As of today we still have not needed to reset a single sensor.

I really like these temperature sensors. They work much better and are longer lasting than any floating pool thermometer I've used, even the really expensive ones. I first bought this model in Feb of 2016, and it only just now died (water got into the back and corroded the batteries...probably would still be going if that hadn't happened). I use mine in my pool in SW Florida, so it's outside in the heat and exposed to elements 365 days a year. To help it last as long as possible, I put the whole thing in one of those plastic waterproof cell phone cases with just the sensor wire sticking out. Then I put it on a little shelf on top of my skimmer basket, so it's protected from rain and sun and hurricanes and whatnot, plus no one in the pool trips over the wire. Probably would have kept working for another three and a half years had water not somehow gotten into the plastic case (most likely when someone changed out the skimmer basket and knocked it into the pool). Still, not bad for $8.

I was skeptical about using these for my Koi pond however after a 5 minute setup, I was satisfied that the results were perfect. I have used a few different models and the only one that worked correctly was the Oregon Scientific unit which is no longer available. This unit works exactly like the Oregon Scientific unit so it was a great chose for a replacement. the wireless is better and does not drop off at time like other models I have used. The only drawback is the probe wire length. It is about 4 feet long as opposed to the 6 foot Oregon Scientific model. So I needed to lower the unit sealed container nearer to the ground to be able to monitor the water at about a foot below the surface. I highly recommend these units and you can actually set up 8 different monitors it needed. I only use 2 but I may add more channels for monitoring my attic temperature etc.