Double/Single Socket Switch Surround/Acrylic Finger Plate - Minimalist Design (Single, White)

Bought these for a diy project where I over cut the plug hole a little, they are a few mm thick and quite solid, easy to fix and just used the existing plug screws. Removed the plug, had to follow the instructions of sliding it over at an angle so I didn’t have to remove wires etc. went on quite easily and held in place with friction of the plug point behind it and covered up the marks leading a nice “shield” to stop finger prints on the wall when pressing the switches. Took about 5mins to fit and fits really well. Comes with a blue protective film that when taken off leaves a pure white finish.

Great finish, quality surround, well packaged with a film protected surface, Exactly as described. I wish that I had checked the size before purchase.

Fits really well and looks really good. Very happy. No need to undo wires, just undo socket and slide over the top.

Cover cuts of wall panels well and look smart. Just pressure held, no screw holes, go around screw holes under socket

Ok did the job but design could be better

I replaced an old light switch, which was a touch smaller thanbthe old one. Rather than having to redecorate for this, these surrounds gives a lovely finish

You are left with just 1 cm surround when fitted which quite frankly serves very little purpose as a finger plate and is not fit for purpose and on top of which you have to pay for delivery and return. Very Poor.

Great look, i would say a bit pricey for what it is but it give a great finish to the new socket i fitted.