Yukon Rear Axle Bearing and Seal Kit for GM

Great product, installed on a wrangler 2016. Good so far.

I ordered 2 sets of these for my 1995 Ford F-250 4x4. I was going to keep a set as a spare but ended up needing to replace the first nut with the nipple for both front wheels. I'm ordering 2 more sets so I have these high quality parts on hand if needed again!

used to repair dana 44 rear axle leak, worked great, old bearing and lock ring have to be carefully cut off and new has to be pressed on, do not beat on with hammer and the seal must be on before assembly of the new bearing will have to be cut off, its not a terrible job but was time consuming, about 12 hrs per side

Everything you need for a single rear wheel. However, be careful not to cast aside the oil slinger--this kit doesn't include one (none do) and it is a dealer part that they often don't have in stock. The oil slinger tabs go toward the bearings. Just be careful to note the set up when you take it all apart. Lots of youtube videos out there. Be sure to pack the bearings with grease when you install as it takes a bit for the differential oil to migrate through the bearings. Some videos have you installing the seal on the axle--DON'T. Install on the wheel side and then put on the axle. I did it the other way (put seal on axle) and had to do it twice (diff. oil leaked). I really like that this kit comes with the bearings and the races for the bearings--they should be replaced together. New bearings won't last long in old races.

Installed fine. Dealership did it. No issues so far. Will update in a year or so

Is a good quality product, fitted my rear JK Dana44 standard axles perfect. Would buy again.

Nissan Titan's changed their rear wheel bearing/seal parts in late 2007 (4/07 onward). My truck is the "early" model produced in 3/07. This bearing set fits my truck same for all (4/04 to 3/07). Recommend you check the build date. The parts are USA quality and I'm hoping for long-term success.

Great quality and fits like it should

Esta bien el producto.

I will always choose Yukon for my gear and driveline parts. Perfect fitment,

The fit was perfect on a Wrangler JK 2014, rear axle, Dana44. The bearings and racers are Timken and are marked Made in the USA. The seals look and feel good quality, but only time will tell.

Nice kit worked great with the overhaul kit from yukon. Brand new rear end on my truck for a reasonable price

Le quedan perfecto a Wrangler JK 2007