Omnimount AB-2B Universal Satellite Speaker Mounts

I purchased a set of four of these to wall mount my Energy RC Micro Speakers.Here is why I am giving this product 5 stars:Heavy duty plastic that is extremely sturdyEasy installation (I installed all four mounts in less than an hour)Included hardware (drill bit, alan wrench, 3 sets of keyhole mounting screws and all the hardware needed for ceiling or wall mounting)Flexibility to mount in multiple directions without sacrificing the ability to maneuver your speakers in a horizontal or vertical direction,Flexibility to shorten or lengthen the mounting postPricePlease note that if you are intending to use this for the Energy RC Micro Speakers, you will need to pick up 1/4" 1 3/4 mounting bolts. You will need to be sure that the head of the bolt isn't to large that it won't fit into the mounting post.

This mount works great for mounting speakers on the wall. You need to make sure to mount to studs as it takes a lot of pressure to hold the mount to the wall. If you don't tighten the bolts enough, the mount can pull away from the wall a bit. This is less of a problem for smaller/lighter speakers, but can take a lot of force to hold up heavier speakers. But this will be an issue with any similar styled mount and these work great for being so simple and non-bulky.

This little gizmo makes it easy to mount a small- or medium-sized speaker on a wall or ceiling. I mounted a center speaker to the ceiling of a wall niche (niche made for the old huge CRT TVs). It works great and is just above my flat-screen HDTV. Would have been difficult to mount without this gizmo...with it, it was a 10 or 15 minute job. They give you the goods to mount it in drywall or a wall stud, with an extension or not, so it should adapt to most any situation.

A good solid and very cusomizable speaker mount! Just wish the bolt that screwed into the speaker was a bit longer because my Energi speakers didn't allow the mount to sit flush against the back of the speaker, but I made it work anyway, no problems!

Strong

These mounts come with all the necessary hardware and were easy to mount. Using them with a set of Energy Take Classic 5.1 satellites and mounting was a breeze with the included 1/4X20 screws. Mounts easily handle the weight of the Energys on drywall alone, no need to mount to a stud.

The mount is ready good for handing up a spkr,but, the pieces can be easy to be bent

This is a great product! Easy to use, top quality, and great customer (factory) service. Note: I inadvertently damaged a part and the factory replaced it at no charge. I now use four of these to mount my back-surround speakers.