FILMEXT blue light screen protector laptop 14 inch

You get two. It's a good Screensaver, and very good reflection reducer. It was just a bit too wide so I cut it to size. I should have used a razor and straight edge and it would have been perfect.

Simple to add this to the laptop. Works as expected.

Product helps with privacy from lateral views of computer screen. The magnetic solution works well and easy to install. It blends well with a black screen bevel. However, the magnets are only at the top. Therefore, the bottom will hang off the laptop screen if one tilts the it below 90 degrees.

Worked great for my HP laptop!

This 14-inch screen protector was a total letdown. It came with no instructions at all, and no matter how I tried to apply it, there were way too many bubbles. On top of that, it makes it hard to close my laptop properly. Only suitable for a monitor, not laptop. Very disappointed.

I have installed several dozen cell phone and tablet screen protectors with only minor complaints - but never have I attempted to fit one inside a bezel - and NEVER will I try again. If I had to do it over again I would do as one person wrote and leave the film on the sheet and just tape the whole thing (at the edges) to the screen. 1) Alignment is difficult as they have you start at one end. You have to get it within less than 1/4 mm or the sides will run up against the bezel. Unlike with a cell phone or tablet, there is no positioning guide to assist with precisely aligning the film. The thickness of the plastic conspires against a gradual peel and stick, 1mm at a time, which works wonders for its thinner cousins. 2) bubbles are inevitable, I think the stiffness of the plastic exacerbates this. Expect to peel back and try again at least 20 times during install. Furthermore due to how thick the sheet is, the bubbles wont go away on their own (some protective films come with micro holes that leak the air bubble over time). The provided cardboard tool does a poor job of removing air bubbles, and rounds over quickly (it is cardboard). I found a credit card with a smooth edge did much better (after the cardboard failed). 3) Peeling back and taking another run at it is very risky as it often results in dust getting trapped in the adhesive which makes the problem that much worse (those bubbles don't go away and the adhesive is not thick enough to encompass them. I don't have a certified clean room - do you? The instructions at the very end mention a steam filled bathroom - that is not a suggestion, it is a minimum requirement. 4) Finally be very careful when peeling it back because too sharp of a bend and it will crease the plastic and then proceed to unstick itself in that area (permanent bubble). Overall this was an exercise in much frustration and left a barely usable end result. I suspect that if I did 10 of them back to back, by the end I would finally get good at it, and have something worth keeping. Practice makes perfect, don't expect the first one to be very usable.

been proven as very effective in keeping my screen scratch and damage free. doesn't impact the sensitivity of my touch screen feature

on these screen protectors is very good. I'm a night reader and before I purchased these my eyes hurt by the time I turned my laptop off. My installation went fine, directions are clear and everything is included that you need for install. Touch screen is still good with the protector in place. Yes, I would purchase again.