🚀 Elevate Your 3D Printing Game!
The TriGorilla Integrated Main Board is a high-performance control board designed for 3D printers, featuring a robust 4-layer PCB and compatibility with popular models like Mega2560 and RAMPS1.4. Note that it is a bare board without pre-installed firmware, allowing for customization based on your specific machine needs.
C**R
Works well after flashing
YOU need to update the firmware via USB. This is usual for mainboards. Check YouTube for directions. I had to use an odd version of Cura from Anycubic website where i also got the drivers and updated firmware.The board came with a bizarre incomplete Mega X firmware, im just glad it has a bootloader. After updating to newest firmware from Anycubic, printer seems to work as good as new.
C**O
Does not appear to work, maybe it's the vendor?
So this is not the first time I have worked with 3D printing motherboards, but it is the first time I have burned out a mosfet (tiny things). So I ordered this to replace mine while I attempt to solder the 10 cent piece back on the board. Updated the Firmware, put it into the printer (all wired up), power on printer and NOTHING happens (other than the power light D2 lighting up). Moved the Jumper back to USB, replugged in the computer, put the firmware on it again (just in case it was my mistake), moved the jumper back to DC, powered on, no different.I can only assume this means there is something wrong with this board. To be sure, I took my original board (the one I need to solder on) and updated its firmware with same .hex. It WORKS (although it has the error because of the burned out mosfet).I will return this board and purchase from another vendor.
G**0
Worked as intended
Replacement for my Mega Pro Motherboard. Flashed the firmware on it and it worked within the hour.
W**Y
No Firmware and won't see SD Card
Needed a new board, however this came with no Firmware. Because there's no Firmware, it can't be seen by computer (Cura) nor can it see the SD card to install anything. It also can't see the temperature sensors and there for won't heat up, not that it can see any prints to print anyways.
U**2
Defective
Tried to replace the board on my mega x because anycubic can't send me working parts and guys what? I think they but their parts from here because the hotbed solder on the board was all bubbled up and had pitting. I realize we're in the age of no customer support but this is getting ridiculous.
B**
HOW TO ADD FIRMWARE
These motherboards (as stated) do not come with firmware. You need to download the firmware from Anycubic website. It is a .hex file. Save that file to your desktop that you can navigate to easily. In cura, you can upload custom firmware via USB to the board. MAKE SURE YOU CHANGE THE JUMPER ON THE BOARD. This will allow the upload of firmware. Make sure to switch the jumper back to it's normal position and power back up normally. Hope this helps.
M**S
Placa defectusoa
La placa me llegó con problemas de conexión.No me permite subir el software, y aparece encendido el led de debug.La placa no se conecta
S**S
Bad Board
Fan bridges shorted if there is no ramp up. Guessing this will occur on all boards and is just a design flaw.
Trustpilot
1 month ago
3 weeks ago