2 Pack - Return Jet Assembly with Directional Return (Twin Pack) - Fits Eshopps

Very good replacement or upgrade, the only thing is that it has a small hole about an inch above the jet! When the water goes down an inch it blasts the top of aquarium and splashes the lights. A small dab of glue takes care of this.

I bought these go on a SunSun 704B canister filter but they sat in a box while I worked on getting the rest of the new 125g aquarium set up. By the time I did get around to installing them on the filter, I found that one of the outputs had a crack in the seam. It wasn't noticeable at first but when the SunSun began pumping water through it, it sprayed water out of the tank and across the room like a sprinkler with a solid 3 - 4 ft. stream. I wanted to return it but the window had already closed so I patched it up with some waterproof tape instead. The repair was easy enough but the cost of the tape did add to the overall cost of the product and diminished its value.

Terrible quality. I ordered the two pack and both of them was stopped up with cheaply molded plastic. I tried to drill one of them out to make it usable but no luck. I would recommend looking for a better brand. I returned them!

Great for the tank, works well. Only drawback was they take a larger tube than the return tube of my fluval filter so I had to run to Home Depot and buy fittings to adapt the hose. The fittings ended up costing more than the return jets.

Using the 266 gph with UV on a 55 gallon aquarium. Can't even hear it. It cleared the tank overnite. But, I wanted precise directional output flow so bought an "Encompass All Return Jet Assembly with Directional Return". It allows to direct flow up/down as well as side to side. It's long/deep enough that there's no noise when water level drops -- of which several reviewers have complained.. Also, has a tiny pinhole to prevent siphon backflow if power outage occurs. Overall great system and am buying another..

Not good. As many here, I experienced leaks. This is cast from extremely thin plastic. It’s very hard to tighten any clamp enough to stop leaking without crushing the tube. It might work for you, it might not. Not worth the savings when you know you can get something that will work for $5-$10 more.

Good for the price

Works well