Spal30103202 12" Puller Fan 12 Volt High Output Curved Blade 1870 cfm VA01-AP90/VLL-66A

So my 2015 Subaru STI launch edition is a stage two built motor a aftermarket 2 inch radiator and was still having overheating issues so I purchased the meshemoto fan shroud and tried to use it. It work well, so I purchased two of these fans. 1870cfm They were broken, The packing is not very sturdy but still worked very well. I had to modify the.Moto fan shroud to make room for the fans to fit there is about an inch in between the back of the fan in the engine and it blows a lot of air. Be careful on the way you wire it up send signal backwards. I blew out a couple of fuses because I did not have thick enough wire.

Replaced some higher cfm rates Chinese junk with these. Omg do they move some air. Awesome. A bit thicker than I expected but amazing still

The media could not be loaded.  Pulls a lot of air through my condenser and uber thick handmade radiator. Had to make a “custom” shroud to attach it to, not the most beautiful craftsmanship but it gets the job done just fine! Keeps the A/C nice in traffic and on a 98° day can keep radiator coolant temps around 10° +\- ambient temps while idle, so it’s a large improvement over stock for sure. You can even feel the air pulling through the grill.Only con I have is that the first one I had ordered, the blades popped off. Turns out there is a little clip that attaches everything together. Looked like it was chewed up and gave out at some point as it’s all plastic? Regardless glad the blade tips are attached to a circle as a whole piece otherwise that would’ve destroyed $1,200 of Radiator if the tips slapped and bounced around on the fins!The replacement one works great after plenty of driving. Would recommend!

Works great!