FEBRYTOLD 12 Pcs CV Boot Clamp, 6 Pcs Small and 6 Pcs Large Stainless Steel Universal Adjustable Stainless Steel Drive Shaft CV Boot Clamp

منتج ممتاز

This kit works perfectly to retain my cv boot which came without new clamps.

Good quality clamps . U need the crimp tool

Measure your old clamp width beforehand., or measure the band groove in your replacement boot. The boot I used, and some other boots I had on hand, needed a smaller width clamp, around 6.5mm. The big one here is 9mm and was definitely too wide. They are heavy duty and I will just keep them on hand.

The clamp was the same width and thickness as the original clamp, and it seems very well made. The only difference was that the original clamp had the 3 hooks/teeth pointing away from the boot and this one has the 3 teeths pointing to the cv boot. This was not a problem for my car because the boot is very thick where the hooks are touching it. In order to protect the boot from the hooks, I cut a small piece of bicycle tire I was planning to place between the teeths of the clamp and the boot, but I did not have to use it. I replaced a loose clamp, so I only took the car tire off for this repair. Removing the old clamp was easier than I expected by inserting a screwdriver in the clamp tightening loop and rotating until the clamp hooks disengaged. Installing the new clamp in such a tight space was very easy and effortless by using a small 4" aftermarket tool similar to the one sold by Toyota. For the tool, I used a 13 mm socket to tighten the clamp.

Worked perfectly on my new cv boot