Nilight 8 Gang Rocker Switch Panel 5Pin On Off Toggle Switch Aluminum Holder 12V 24V Dash Pre-Wired Green Backlit Switches for Automotive Cars Marine Boats RVs Truck, 2 Years Warranty

I put this in my jeep and used 1 rocker to send the remote on power to 6 amplifiers, ( not the main power but a small amount to turn on the amps. I used 1 rocker to turn on my whips, ( 6 foot LD lights), and used 3 of the rocker to work the main LED light bar and 1 to turn on the small light bar under my winch, and the 3rd for my 2 LED lights on my back as reverse flood lights. It works perfectly !! made it quicker and easierto wire everything, you would not believe the amount of wires in my jeep. Great product, would buy again. I will post pics. after i finish the dynamat and carpet.

Works great and cheap

The pre wired toggle switches simplify the rewiring of my boat .

Decent product .. does the job … as like other reviews .. a little cheap in quality with the switches themselves… most of the ones that “broke” I believe is because they did not use the tab to remove the connector. Keep in mind.. these spade connectors are not heat shrieked or waterproofed .. i replaced them all with marine wire and heat shrink spade connectors .

Purchased this unit to make a new switch panel in my 26 year old bay boat.. I did replace a few switches with rockers for necessary applications.. Pre-wired and the provided jumpers were nice.. Not sure about it's durability or longevity yet.

The way the lights in switches work great. Switches turn off and on perfectly thank you.

Still have room for more wiring

The media could not be loaded.  Easy to use people complain about something that they're probably just overworking and over complicating good piece of equipment

If your thinking of removing the switch rocker from the switch body, (even with the correct tool) the switch body pins that the switch rocks on and holds it in place will break, they are very soft. In my case I was removing one so that I could replace an existing one on my boat that had faded and looked unsightly so rather than replacing the wholse switch I just used the rocker from the new one and that turned out well n( so the rocker survives but the switch does not). In my case the good news is that the rocker it self stayed in tact and it fits my OEM boat switch bodys ( it is made to standard and that's good news as some of my switches are momentary or 3 position ( Hard to find replacements) . I have also used one as a stand alone addition and it is functioning well so I'm not displease with the purchase just wanted to let people know they are not perfect. If they changed the tool slightly that makes the switch body they could probably fix it fairly easy. Im hoping its not a material issue and I don't end up with melted switches through bad materials.