Large Scissor

The replacement springs for the Victorinox scissors work well!

Large size spring fit the pliers on my pre-2007 Victorinox Tinker perfectly. Wish I hadn't waited this long to replace. Will save the others in case the pliers or scissors need them again in the futur. A little tricky to install; recommend a pair of pliers to get them in and the a small punch (or a small blunted nail) to properly center them in the hole.

A great product at a great price. This is something you don't know you need until your springs break on your scissors. Removal is with pliers and is pretty straight forward. The installation is a little more tricky. You have to hold the spring loop over the space it goes it while pressing it in with pliers. If you have a friend with a steady hand this can help a lot.

I ordered the multipack of large springs, which fit knives over 3 inches long (closed). I watched 2 quick YouTube videos to see how best to get the old one out and the new one in. I used a pair of needle-nosed pliers to do the job, and I had my new spring installed in less than 2 minutes. The spring seems to line up just right, and my scissors work perfectly again. My knife is over 30 years old and has a lot of sentimental value, so I was really happy to be able to repair it so easily and affordably.

Fit properly, sent quickly.

I easily replaced the broken spring in my Explorer Swiss Army Knife. I worried that I would need a pin press or a punch, but a 6 inch needlenose wiggled the old out with no problem. I pressed the spring in with the same pliers. After removing the old spring, examine the hole. One side has a chamfer and looks bigger. Press the new spring in from that side.

One deficiency of the Victorinox "Swiss Army Knife" is the scissor design, where it uses a spring that will eventually break due to metal fatigue. If you have owned one of these knives for long enough, then you will experience this kind of failure. I've had a variety of these knives for many years, and these failures are very common - but fortunately easy to repair, as long as you have the right spring available. It is therefore very handy to be able to obtain these replacement springs here on Amazon, and I was able to remove the broken spring and install the replacement spring relatively easy. My only reservation is that I am not certain that this spring is a legitimate Victorinox replacement part, since it is not being sold here by the company itself but by one of the third party sellers. I'll have to see how durable this turns out to be, and if I find that this replacement spring fails sooner than the original spring, then I'll return here and update this review with that information.

Worked great for pliers on Victorinox CyberTool 34M. These look like the standard Victorinox pliers. They measure 7/8" from center of fulcrum (pivot point) to tip of jaws, and 2" from fulcrum to end of plier handle.

Slight modification needed To the back As it is convex Instead of Concave

メール便なので届くのに多少時間はかかりました。 バネの交換は、穴になかなかはまらず苦労しましたがペンチでバネが変形しないよう加減しながらはさんでなんとか完了しました。 これで何年もバネ無しで不自由していたのから開放されました。

Gut verarbeitet, passt super

Perfect replacement for the spring in my very old Swiss Army Knife.

This was one spring, not a 6pk as photos clearly show. One of the pictures clearly shows a pk of 6 large springs. Nowhere does it say one one, but you are lead to believe it is one pack of 6 on a photo showing a 6 pk, plus a seperate photo of 6 springs. Also, one small spring was delivered, not six large, big difference. Returned for refund.