Camco Recessed Motorcycle Wheel Chock - Accommodates Most tire Sizes - Constructed of Powder-Coated Steel (66101)

The unit would be perfect except the square holes are a little too large and the stove bolt spins when the locking nuts are about half way on, regardless of how much pressure the person above puts on. Easiest solution is to put a regular nut on as tight as you can and then install the locking nut - see picture. Or regular nut with a second washer - locking. Suggestion - pick up the butyl tape to work as a seal because the are some big holes in the corners where water can get in. The box also has four holes in the corners, I sealed those as well. If water gets in i'll just clean it out.

Get the bigger one. Ad says motorcycle they forgot to say child’s motorcycle.. The pic shows the tire in the bottom of the hole and that will happen with an 8 inch scooter tire. I have a 19 inch tire. I removed the flip up part and the tire was still a half inch from the bottom. I did some drilling and cutting so the tire goes further forward but it’s still an inch from the bottom. My 1st review was deleted. I’ll add the pics but not the video. 7 1/4 x 12 3/8 x 2” Deep hole required. Check the location of floor supports because you’ll need to go between them. This design puts about 10 times the pressure on the bolts as applied to the flip up part. They’re using 3/8 carriage bolts. My 500 pound motorcycle gets loaded today for a 1350 mile trip. I’ll cut a piece of plywood to fill the hole. Good luck..

Let me just say the person who designed these has never owned a dirt bike or let alone even seen one. Let me start by saying I am dumb for not opening the box earlier. I bought theses for my sprinter moto van and just pulled them out yesterday to install them and they are built for mini bikes. I feel like I bought a item off wish and got totally ripped off. These things are so small the wheel doesn’t even sit all the way in the chock and now has 2” of less front support because these are made to small. What a joke and now I am stuck with them.

A little more than I wanted to spend but it's sturdy. I got what I needed when I needed it.

Doesn’t fit.. tire cant touch the inside bottom of the plate even when the front tongue is unbolted and removed !