INJORA RC Roll Cage Rock Buggy Body Shell for 1/10 RC Crawler Car Axial SCX10 & SCX10 II 90046 (Green)

Assembly instructions are not in English so pictures is all I had to follow. Ended up installing the skid plate/motor backwards. Battery tray is hard to mount as screw bolt assembly is rough to reach as it it interior of the cage. Should have come with one more metal spacing rod to brace the chassis together. Jury is out on durability as it is nylon. Could crack while taking a tumble. So far, mounting of electronics and wiring is nice as there is room. Performs well. Very light which helps keep the center of gravity low. It has good looks.

Had my wife order this so I could build a crawler. Had a bunch of extra parts laying around for three monster trucks that I have built so I thought a crawler would be fun. cage is extremely petite for a 1/10 scale cage. I’m not sure if they sell their own parts or not but be prepared to do a lot of modifications to get everything into it. It don’t seem to be very well laid out it was a decent price so you get what you pay for.

The plastics a bit soft but they hold just fine. For the love of all that's good in the world put the battery tray in as soon as possible. That was the only difficult part to install because I did it last. The tiny nuts and bolts wont hold the roof or hood body panel on for long so plan on zip ties. You very likely will have to trim the battery tray but I did and it worked out fine. The battery straps included aren't long enough for anything so order replacements at the same time. An axial 3 gear trans from a 10 or 10.2 will sit to low and the motor will hit an upper link mount. I put a stealth x trans in mine and that worked out wonderfully. I already had 100mm shocks laying around but I'll eventually get 140 or longer for it. That being said it flexs perfectly and crawls capably. I went straight axle I do plan on getting axial ar60 capra axles for it. You have to use axles that support a servo mount.

Nice budget build. Put together your components and create a one of a kind crawler. Even more fun than a kit build!

This was a $10 fit-and-finish part selling for $40. The big issue is stripped threaded plastic holes, meaning poor connections where strong connections are needed. These will certainly not hold together for a solid fit over the months. Also the center plate/transmission plate was not square and flat, meaning it took a hard struggle to get the link rods into the slots, and then the screws holes to line up. Others seem to have had better luck with this product, so I may have gotten one from a bad batch, but mine went back.

First one came with wrong hardware. Seller took care of this in less than a week. Great service.Went together easy for my Danchee Ridgerock conversion. Plastics seem, ok, no glass fiber blend, probably just nylon. Cross braces are metal. Good value for the money.

Very small nuts and bolts went together easily

Easy to put together, looked great, not super cheap feeling, only downside I found is battery mount doesn’t fit quite right with the transmission I have, currently have it mounted at a slight angle using 2 of the mounting holes