JENOLITEEpoxy Putty Repair Stick | TITANIUM | Industrial Strength Epoxy | Repair & Rebuild All Metals | Waterproof & Temperature Resistant -40 to +260°C | 112g (7 Inches)

Easy to use. Formed strong repair quickly.

Very maliable sosimple to mould into shape works well.

Wanted this to provide insulated ends on a quench tube for forging so I could pick it up when it was at 250C and filled with hot oil. Used the putty to give me an insulating handle at each end (still wore blacksmiths gloves). Did pretty much what it said on the tin. Set rock hard over night and provides a reasonable thermal barrier.

I followed the instructions and worked perfect for what I used it for

Product was strong enough to fix a kitchen pulley clothes drying system great back to working condition

Mixed easily, applied to enamelled cast iron. Used a little moisture to mould into position. Hardened up by the next day, painted with VHT black paint. It has been subjected to heat around 250°C every day and has not degraded. Quite pleased with the performance.Further use to repair the wear within the catch on the same stove as above, as the cast iron that the stove is made of seems to be very soft. Worked a treat.

I have been using Jenolite Titanium Epoxy Putty and its always been good. Unfortunately the most recent tube I purchased did not set as it should. Having carefully cut the amount I needed I started mixing it as per the instructions. To my surprise after a few minutes of mixing the epoxy started heating up (curing). I tried again, with the same results where the epoxy would start to heat after 2 minutes and then another 30 seconds later it is not moldable at all and becomes brittle. The instructions state that the product gives a 1 hour working time which has held true with previous purchases but unfortunately with the most recent purchase you can barely get past the mixing stage to be able to mold anything close to what you need for job in hand In addition to this, i managed to get some in between a joint before it set and 24 hours later i tested the strength of the joint....it snapped in two without any reasonable pressure. I also noticed the colour of the product is a lighter shade of grey compared to previous purchases which have been dark grey (see photo). I will purchase another tube and check previous purchases have been from another vendor perhaps.

this takes a lot of mixing, done with you squeezing the putty, to get the 2 components mixed. Have used other putty's in the past that were a lot easier to mix.....

le produit est moins facile à malaxer/mélanger que d'autres marques mais globalement "il fait le job"