2013-2018 BMW 3 TAILLIGHTS

Installed on my 2014 BMW 328i and they fit perfectly. They function as advertised and I did not receive any error codes after install. I took a chance on this lesser know vendor and saved over $200 and I'm glad to say it paid off! The lights are well made with high quality material and they were packed in a thick foam case to prevent damage during shipment.

my taillights came in cracked, and with multiple fitment issues, overall they look so nice and i love the style so i’m very bummed they came like this, everything works nice and smooth the lights bright, install was pretty simple other than fitment issues. update: they reached out to me not to accept responsibility that they messed up, but to blame amazon for the fitment issues. wouldnt help me for anything. 0/10 do NOT recommend these guys.

Lights look great! However after 3 weeks when I get a car wash the passenger trunk light gets moisture inside and won't work for at least 24 hours! Veey bummed about this! I also had to bend the metal tabs on the trunk lid lights to get them to accept the keeper tabs on the lights. Hopefully the seller will fix my issue with the moisture! Stay tuned

Fits pre-LCI f80 M3. Looks great, be aware though you may need to slightly modify/add rubber washers to the studs on the car for outer lights to get them to line up correctly (the studs that go through the light housing and a nut goes on). Also had to remove the outer lights center mounting guide (between the two bolt holes) to run the wire through and up to the trunk lights. If you go that route, ensure you have enough slack in the wire so that the trunk can open and close normally. I also had to adhere the wire to the inner fender wall to keep it from snagging on the trunk arm plastic trim (where it exits the trim). You may not run into the same fitment issues but thought I’d mention it just in case. The lights look great and fitment is as good as the factory lights after the modifications, only time will tell if they last but so far I’m happy.

So I do avionics as a profession and was expecting to have to do a bunch of rewiring, not at all, this comes with the resistors already wired in, so the only difficult part was trying to find where to run the wire for the sequential wire for turn signal. I ended up drilling out the part of the light that has the nub for alignment and ran the wire through that hole and then up the trunk hinge, zip tie and your done. The install book tells you that you will need a soldering iron etc., you won't need anything but the tools to get the lights off, everything else is literally plug and play, the only thing to keep an eye out for is there are two connectors for the light not on the trunk, make sure you use the correct one by looking at the pin arrangement on the old one.The look is fantastic, they are bright and the sequential turn signal and the dragon breathing when it turns on is pretty bad ass.

It worked fine for the first month or two but then my right side blinker stopped working. I tried taking it to a professional shop and they said they didn’t know what to do either. Manufacturer says there’s a one year warranty but it’s impossible to get ahold of them. Please reach out to me

The appearance is consistent with the ad. The difference with these is there is no side marker running light, as I’ve seen on other similar products. But with that being said, the glow of the lights is brighter and more vibrant. There is no locking tab on the trunk section lights, compared to the original ones which do have. So the installation is easy but could be more secure if it had these tabs. This runs the chance of a not so tight fit if you don’t tighten the carrier bolt

I just love it, great quality, looks extraordinary and just so sexy.