The HUBOSD8 has been engineered to provide the highest possible performance and reliability Independent from flight control, which means no data communication with flight control It is a multifunctional HUB with PDB, BEC 5V/2A &12V/500mA, Current sensor 140A, STOSD8. It is specially made for the mini FPV Quad. The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8 support Plug & Play, no complicated settings needed. WHAT IS THE STOSD-8 Based on STM8 & Max7456. STOSD-8 is a new simple OSD hardware & software solution for use primarily with FPV Quad and without protocol of flight controllers. Plug & play, No complicated setting. Features: AUTODETECT PAL/NTSC LOW VOLTAGE ALARM DYNAMIC ON SCREEN INFO EXCEEDING MAH ALARM PLUG AND PLAY:You can use it with default firmware & settings. No PC connection needed if you don¡¯t want to change the settings AUTOMATIC FLIGHT TIMER FIRMWARE UPGRADABLE MIN.VOLTAGE & MAX.CURRENT RECORDER AUTO BATTERY CELLS DETECTION ONSCREEN PILOT ID For more, please visit http://www.stosd.com/ You could also download maunal from here https://www.dropbox.com/s/rc4870pbbue0ohs/PDB%20OSD.pdf?dl=0 - 2oz copper, 4-layers &1.6mm PCB. - 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 12V outputs. - Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads - 1x Serial port (RX, TX, G) - Dimensions: 46x36x4mm, Weight: 8.5g - Mounting holes 30.5mm square spacing Designed for RC Receivers, Flight controllers, OSD, and Servos. DC/DC synchronous buck regulator. Voltage: 5.0 +/- 0.1VDC Continuous current: 2 Amps (Max.2.5A 10s/minute) Output Ripple: 40mV (VIn=16V, VOut=5V@2A load) Short-circuit tolerant (5 seconds/minute) Linear regulator, very low noise. LC Filter is needless. Designed for Video TX or FPV camera. Continuous current: 500mA@16V IN, 400mA@20V IN
Trustpilot
2 weeks ago
2 weeks ago
