ACDC WIRE AND SUPPLY ACDC Wire and Supply 10' EA THHN THWN 6 AWG Gauge - Black White Red + 10 Green Ground Hook Up Building, THHN-6-10-10

This is good quality wire. All 4 pieces are listed as "THHN or THWN-2". These are from different manufacturers: Elecon - made in Venezuela Viacon - made in Mexico Southwire - no location that I could identify These wires have thick, tough jackets, and thick stranded copper inside. These are a good value and about the same price or cheaper than the big box stores and you don't have to wait around for an employee to retrieve it. The length of each wire I received is approximately 123 inches, or just a hair over 10 feet. Note that this listing is "6 AWG Gauge - Black White Red + 10 Green Ground" which I understood to be a 10 gauge green wire but I received a 6 gauge green wire. I don't have any complaints unless I can't get all 4 wires to fit through 3/4" conduit. Overall this is a good value and I would purcahse this again!

This wire arrived exactly as described and was a good choice for my project. The insulation is thick and durable without being overly stiff, making it easier to route and work with than I expected for 6 AWG wire. The color coding was accurate, which helped keep everything organized during installation. The copper conductor appears to be high quality, and the wire stripped cleanly without damaging the strands. It held up well while pulling through conduit, and the insulation showed no signs of cracking, splitting, or scuffing during installation. Each length measured as expected, and the wire arrived neatly packaged without excessive kinks or tangles. If you're using it for electrical projects that require THHN/THWN wire, it performs exactly as it should. Overall, this is a solid, well-made product that met the advertised specifications. I would purchase it again for future electrical projects.

Just right of length for my EV charger install, flexible enough to work with , good value prompt delivery .

This set of three 6 gauge wires and one 10 gauge wire is exactly what I needed to connect a 50 amp 240 volt receptacle for electric vehicle charging. All of the wires were branded and properly labeled. The seller was very helpful too! I would not hesitate to buy the same product from the same seller if I need to do a similar project again.

Came on time and is high quality 6 AWG. All four colors same AWG. Only 4 stars because description seemed to say the green would be 10 AWG, but is not 100% clear. My distribution panel had a place for the 6AWG neutral, but no grounds available for 6AWG. I happened to have some 8AWG green on hand, the panel would take 8AWG ground, so all was OK, and I put the green 6AWG away for another project.

Needed some wire to get my generator wired up from my 50 amp inlet to my breaker box (seems many others use it for the same reason). This was the ideal length for what I needed (was just over the stated 10' length, all were within 1/2" length of each other), and was cheaper than anything else I could find local or online. Just needed some conduit to run it through and worked just fine. I used 3/4" conduit and was a snug fit, don't think it would fit in 1/2". While I kind of wish this was solid instead of stranded, the stranded is easier to run through the conduit (I had 2 90° bends to run it through as well as a few bends in the breaker box) and wire up, and I will not be running more than 40 amps through it.

Bought this so I could install a 50amp outlet directly under my electrical panel. This was the most cost-effective way to get the wire needed for the job. No complaints. I still have about 7 feet left for another project perhaps.

CDC Wire and Supply’s 10' THHN/THWN 6 AWG is a solid choice for residential and light commercial projects. The insulation is tough yet flexible, making it easy to pull through conduit without damage. Conductivity is excellent, and the labeling is clear for inspection. A dependable length for tight runs or panel upgrades. The green wire is 10 Gauge.