EPBOWPT RGB LED Strip Accessories (24v)

I purchased this for my 3D printer and it worked fine initially and for 2 months after the install. However I was in the middle of a print when the system controller shut down due to a thermal runaway message. Investigation showed that the 24V PSU had quit working. Further investigation revealed that some component had dramatically failed as bits of something came out when i shook the unit.Amazon support was great and I obtained a replacement unit which worked for 3 minutes before it too died.I notice there's now a note on the product page that indicates this product has a higher than average return rate. Caveat Emptor.

The 110/220V switch is really flimsy, but it does the job. I have an approx 100W load (LED lights), and the fan runs duty cycle of about 5-10%. I was hoping it would stay quiet with such a small load (compared to its rating), but can't complain too much. My first one got a little banged up in shipping, I didn't even want to try it, so returned it and ordered another.

so get this...it comes in the mail in a very thin padded envelope. when i open the package screws (yes plural) come flying out of the package - these WEREN'T from the screw terminals! the edges were bent onto the screw terminals. and despite loosing several screws - the case still contained something that banged around inside the case when shaken.

Works great. There's also a temperature-regulated fan in this unit, not overly quiet, but only on occasionally.

Works!!!! Shipped at 24.2 volts has a nice feel to it. Clean and tight This will power a ISDT lipo battery charger.Comes in white box no cords, There is a plastic guard over screws for safety

bought a bunch of them for a big project and a few didn't work. The internal surge protection does not work either. fried out 5 of these guys