Blacksmith Anvil Hardy Cutter Tool 3/4 inch Shaft Hot Cut Tool Blacksmith Anvil Forge Tool Shank Cutter (Black)

Works well, fast ship, good price !

I didn't expect much from this tool since it's so cheap but I expected more than I got. I had researched proper use of such a tool in the past so I didn't go into it blind, but the tool began to bend and break immediately. After a few more attempts of using it, entire pieces had flaked off from the tool and after inspecting it it seems to be made of cast steel. For a tool with a use of this kind, cast steel is simply unacceptable. It fit right in the hardy hole so I have that to be thankful for, but I got two uses out of it before it broke on me. I'm disappointed. But it did inspire me to make my own cutting hardy, so I suppose there's that. Avoid this tool. Buy one from a reputable blacksmith shop. The increase in price will be worth it, compared to wasting money on a cheap cast steel tool that you won't even get your money's worth from.

Great tool... 3/4 inch shaft I had to grind down to fit a 3/4 Hardy hole opening in my Vevor Anvil...

Works great 👍

It might be called out 3/4 but someone quit at a very large metric conversion , so be prepared to spend some time taking it down to 3/4.

I bought this to try and save a little money. Instead I wasted money. This is not cold rolled hardened steel like it says. It is cast steel, breaks easy, the edge dents with almost no effort, and it broke when trying to adjust the thickness of the shank so it would actually fit in the hardy hole on my anvil.

I received it fast and was not difficult to adjust to my hardy hole. However, with an eighth of an inch round bar heated up the edge was easily dented as a cut off by the bar, not even the hammer. The cutting edge needed to be round down and hardened.

Made good for cutting your melt in too

Not used yet, should've fit vevor anvil (30kg) but hole needs tidying

Not a great tool. Unfortunately it's way too soft and cutting soft metals like mild steel created massive indents in the tool. I tried hardening it to fix the issue but that didn't help. Avoid this tool.