CONQUER HSS Deburring External Chamfer Tool for Metal - Quick Release 1/4" Hex Shank Drill Bit 1/8"-3/4"(3-19mm), Thread Repair & Countersink Bit for Stainless Steel, Copper, Aluminum & PVC Pipe

Nice. Works great! Would buy again

Works good. I use on different bolts I've cut down if to long. Makes it easier to restart

It works ok but there better for the money spent

So far, so good with this external chamfer tool. I used it on a job that called for several pieces of threaded rod. After cutting the rod to length on the bandsaw, I ran this tool over the ends with a drill on LOW speed. Perfect chamfers! The nuts easily threaded on every piece.

Use this for deburring cut off all thread rod or bolts up to 3/4". A few turns with this and the nut screws right on like new. Very useful and easy to use. Carbide cutters clean up damaged threads on bolt ends where a nut just won't start.

Well made, much better than doing it the hard way

not so great, kind of useless as the deburring metal is weak

I wanted to deburr some strong steel and some rebar. It did the job much faster than I expected.

I purchased this for reforming the end of the bolts. I cut grade 8 bolts for different applications on site, after cutting the finish is rough, this tool makes the end smooth and the nut thread on easy. I must say this is money well spent works great and will purchase again! Ps. Use this with a drill mine was home at the time impact doesn’t work too great but does the job.

Great for chamfering brass if you are a hand loader. Best tool ever for it.

Works well

Used it on vehicle wheel studs and cut with ease. Chamfered the stud perfectly.

Scrap après 2 semaines, beaucoup trop cher