DYS F4 PRO Flight Controller OMNIBUS F4 STM32 Microcontroller Integrated OSD DSHOT Flight Control Board

Love the OSD on this thing. Makes tuning a quad eazy.

board blew up one of my ESC's upon first power up. One of the motor channels on the board appeared to be bad. This is my 3rd attempt at getting one of these boards working. The first two had bad BEC's built in and could not handle a 3s battery without cooking. I am giving up on trying to use these boards. I did manage to get the non pro version without the PDB built in working, but I had to connect a 5v bec into a 5v channel on a motor channel. These omnibus boards just seem to be plagued with problems as far as my experience.

Very sensitive I didn't have any luck

My favorite FC by a long shot. I use most features this board can work with, amazing board. I use this in 3 different quads. I didn't like the 4in1 DYS ESCs though. They seemed to produce some unusual video interference. Another thing, when soldering the ESC signal pads, be very quick. They seem to be easily removed. Also, this board is coated with a plasticizer, so it should be water resistant.EDIT: I have two of these at this point, and BOTH of them have had the esc signal pads come off. This is definitely a quality issue.

Not a bad flight controller if you use good quality capacitors to eliminate all the noise this thing causes.

I have several of these flight controllers now and I paired each of them with either the DYS 4 in 1 20A or 30A ESCs. When used together the flight controller plugs directly onto the 4 in 1 ESC using an 8 pin header--no wires necessary (although you'll still need to solder your receiver and camera connections).I haven't had any problems with the FC or ESCs. They're easy to tune, and they don't seem to be overly sensitive to vibration. The build quality of the board is excellent!They also come with high quality soft-mounting grommets, mounting screws/standoffs, and an XT60 with silicone wire leads already attached.If you're aiming for a very clean build with high quality components it's hard to beat this setup.

Complete garbage, do not buy, I personally build almost 40 fpv Quads the last season. this controller was put into one of the last builds I did and subsequently put me to far out to return the product. I would seem the only way to guaranty you will get a good product from amazon is to use it immediately. PID's have to tuned to incredibly high numbers as well as rates and still has no stability, I fly only rate mode using air and anti gravity and this FC is useless for acro or race. Do not waste your money.

Regulator blew after 4 flights. Waiting for a response from DYS.