5Aplusreprap 3D Printer 0.4mm V6 Nozzles - 20Pcs High Precision V6 Brass Nozzle for E3d V5, Pursa I3 MK3, Anycubic I3 Mega with Nozzle Cleaning Needles, Non-Clogging, Good Durability, Easy to Install

These are your average brass nozzles with some nice extras. I have made use of the wrench and nozzle cleaning needles. It may take you a while to go through 20 nozzles, but you want to have extras on hand for when you need them.Just make sure these are the right ones for your printer. I put them in an AnyCubic i3 Mega.

Bought these to use on my Kobra Neo and my prusa mk2s

For some exotic 3D printing filaments, a hardened steel nozzle is recommended because brass nozzles can be quickly eroded by these filaments. I like using brass nozzles because they are cheap and conduct heat well. They may only last a print or two of abrasive filament, but it’s easy to replace them and so I quite often keep using the brass filaments.I have an Ender 3 Pro 3D printer that I’ve been using for the last 4 years. Recently, I replaced the standard hot-end (which had given me great service with a Phaetus Dragonfly all-metal hot-end. I didn’t realize at the time of ordering, that this hot-end used E3D nozzles which meant that all my MK8 nozzles for the original Creality hot-end could not be used. I needed a bulk order of the E3D-type 0.4mm brass nozzles in order to fully use my new hot-end.These 20x 0.4mm nozzles from 5Aplusreprap seemed to be what I wanted and so I ordered them. They fitted my new Dragonfly hot-end perfectly. I’ve never had a blocked nozzle, but I feel that there’s always a first time and so the included cleaning needles were well received. I pushed a cleaning needle through one of the nozzles and it was a very close fit indicating that these parts were made correctly to a tight tolerance.In use, I’ve tried one of these nozzles with ABS filament and I’ve been very pleased with the results – nice clean prints, no stringing, blobbing, warping etc. These are good nozzles at a really low price.

I receive these, and the quality and the workmanship of these nozzles is great. I was disappointed that they would not fit my reality ender three pro. That is my problem and apparently I did not look at the compatibility. But if these will fit your printer, they are nice.