Toyota Genuine 00258-0000C-21 Clear Coat Touch-Up Paint Pen (.5 fl oz, 14 ml)

It gives a good covering protection

Good to have

The pen end and the brush could be a lot better, they are both quite low quality. The paint itself is good but applying it with this is a total pain. I ended up just buying third party paint pens which were much better than the toyota ones.

I used this on my Honda and it was just clear coat so just as advertised. Be careful when opening up the bottle the fumes were nasty. Don't rush and apply slowly and generously so you don't worry about putting too little and some spots are still open. It's pretty watery.

I had a dump trunk drop some rocks on me and gouge the plastic in my bumper. I had someone try to touch it up for me, but without extensive work, it looked pretty bad (photo 1#). Using the 040 white base coat, followed by the 070 white pearl, then the 00C clear coat with some sandpaper and polish, I was able to repair the damage myself. Be sure to clean the area well with Dawn soap to remove any wax. Avoid touching the chip with your fingers so you don't introduce oils to the area. If your plastic is gouged and has raised edges like mine (it looked like teeth marks), use sandpaper to remove any raised spots. Take your time with the base coat and use the brush. The ball point on top of the bottle is useless. Just put down enough so that it's completely white and that no metal or plastic is showing underneath or at the edges of the chip (photo #2). Once that dries, add the pearl coat. I did a few coats of that, then used 1000 and 1500 grit wet sand paper to work out any raised spots and smoothed it down (photo #3). Then I gave it one last light coat and hit it gently with 2000 grit. Once that dries, I added the clear coat. You can apply the clear coat past the edges of the chip. Once that fully dries, use 1000 grit, then 1500 grit, and finally 2000 grit wet sand paper to smooth it out. Finally, use something like Mother's polish to bring back the shine (photo #4). Give the paint a few days to cure, then add wax. I can barely tell that I had a pair of 1/2" gouges next to each other on the edge of my bumper.

as advertised

Good match with the 3 base, pearl, and clear. I’m giving it 3 stars due to my package took a lot longer because it was shipped out wrong. I couldn’t do the normal how was your delivery review so it has to go here. Product is 5 stars.

As other reviewers have stated, this is a three-coat system. You will also need 00258-0070C-21 (white pearl paint) and 00258-00040-21 (white paint).In a nutshell, you prep the area by removing any surface grit\dirt\rust, then clean it well with isopropyl alcohol. You then lay down a thin layer of 00258-00040-21 white paint (as a base-layer). After it cures out (I waited 4 hours), apply a thin layer of 00258-0070-21 pearl paint. After it cures out (again, I waited about 4 hours), apply a thin layer of 00258-0000C-21 clear coat and let the area cure out overnight. You should be good to go for washing and or waxing in about 3-4 days, but I waited a week, just to play it safe.You'll definitely want to apply this when it's warm-to-hot out, and not any cooler than about 65° F. If you can do this in the garage, all the better, as there will be no dew to settle on the area, overnight.