JSP ManufacturingSEA DOO Part # 271000290 + 293200024 Neoprene Seal 271000101-271000002 - SEADOO SP GT XP SPI SPX HX GS GTX GTS GTI WEAR Ring 140MM

These solid wear rings are good for the average Sea Doo. If you are trying to squeeze every last bit of speed out your ride, then this is not for you. Go with the OEM part. Otherwise, they work well and last a long time.

Arrived quickly as usual from JSP. Fits well on my GSX

I put it in the freezer overnight and it slid right in. Getting the old one out took more effort than expected, but this one fit perfectly and the ski runs much better with no blowby at all.

What a waste of time and money I bought this part and put it in and threw in the impeller cause I was in a rush to get on the lake. I got to the lake and my ski was cavitating. I drove all the way to the lake and could not even ride my ski once I pulled it apart I could see that on one side of the impeller had a large Gap between the impeller and the wiring and a smaller gap on the Opposite side anyone That has done work on the ski knows that once you put these things in They do not come out in one piece. So now here I am pulling my ski apart again to cut this wearing out and buy an OEM wearing do not waste your money on this product it’s trash it is not symmetrical the gaps are too large around the impeller and will ruin your lake day.

It fir perfectly and was good value for the money.

Fit perfectly in my 1993 seadoo XP. Easy to install!

GTS SeaDoo .

Material looks good and expected it to wear well but even after over night in the freezer there is no way this would fit even with a 2x4 and mallet.Look at the picture and you can see why. It's flared at the ends. I guess if you had a lathe you could skim it.What happened to quality control !!But with caution and check out the Outside Diameter !!

Was not within specified tolerances, old warn out part was better

Item is as described however it does not fit properly in my seadoo pump. Also, it was not perfectly circular. I should have sent it back as soon as I opened the package but wanted to give it a try. The impeller gap spec is .020" and this ring and my impeller is .032" now I need to destroy it to remove it. Will not buy another JSP ring again. Junk.

Product fit perfect and shipping was quick compared to my local dealer

Fit parfaitement

Item looks nice. It was a very tough install even with freezing the ring. Upon install & test I got acceleration similar to my old OEM wear ring that was badly damaged. Purchased an OEM an my acceleration issues was fixed. This unit is out of spec and round.