Cutting & Tapping non drip compound - for drilling sawing tapping all steels alloys cast iron & Aluminium

Ct90 does exactly what it says on the tin. It gets plenty of use in our workshop and is probably used most days for one job or another and so far has lasted 6 months and we're maybe halfway through the tin. I opted for the tin rather than the bottle of Ct90 liquid as I thought it would last longer and I think it has. Product has a nice smell in use, almost herbal, which isn't a major selling point but make it much nicer to use than other cutting fluids that get hot and start to smoke releasing plastic and silicone like smells. Can't see any negatives with this stuff and will likely buy another tub in 6 months to replace the current one.

Good quality cutting oil as I would expect from an oil product with WD on it. Used for thread cutting and drill, helps with a nice clean cut. Also squirt a bit on the hacksaw blade when cutting steel bar, makes cutting smoother. Worth having a can nearby. I would actually prefer the product in a trigger spray rather than a spray can as there is more fluid control. 👍👍👍👍👍👍

Work well best to stir can first as solid

Great stuff, use it for everything

Great for drilling vertical holes but you need to apply more to the top of the hole when drilling horizontal ones and allow it to melt into the cutting bit. Good product

The same stuff I use at work. Good stuff, makes the garage smell like I'm at work.

Seemed to do the job. Somewhat thicker than I was expecting, but that just made it all the easier to apply. And once applied it stays, even on a vertical surface. I suspect this tin will out last me (and my children).

First outing for my hand dies. I was strongly advised against high speed cutting spray oil, so this heavy, CT90 non-drip compound was used. I was satisfied with the finished threads, and hopefully it has protected my 1/2" cutting head.