Pc-60 A05FN Front Panel Clip 3d Printed pt-jt01 female and male White 5 pcs and 5 pcs

They are a perfect fit for the Lian-Li panel clips. They install easily, and when the panel of the case is reinstalled using them it fits firmly.Unfortunately, within a couple weeks, the "female" portion of the clips will break. Every single one of them.OEM clips are out there, and can be found with a bit of searching. They turned out to be the correct way to go.

lian-li is probably the finest, longest lasting computer case on the planet.....this thing has been 5 different units over the years..........but bits and pieces wear, here and there. it was good to find these.

They fit but are likely 3d printed and too stiff. One broke 3 weeks after I bought it. But they do work.

The plastic used in making is extremely poor and little. don't waste your time and money. You will very disappointed.

The plastic clips on my beautiful, brushed aluminum, Lian Li tower case had turned brittle over the last 10 years, and were literally cracking into pieces. These fit perfectly. I did learn one lesson however, when pulling the door panels off my Dodge Dually to upgrade the speakers a while back; put some lubricant on the clips in case you need to pull it back off for some reason. These clips really fit tight, so I put a dab of white lithium grease on the tips, and they snapped right in and held like a bear trap.

They where we'll printed but they didn't fit my pc case.

Quality is not good....had to debur to install, and the plastic is simply too brittle, felt like polystyrene or something like that. 4 of 5 shattered while trying to attach the faceplate.

I needed these because the clips in front of my computer case had all broken. Since the front panel attaches to these clips the front panel would not stay on. They fit my Lian Li PC-9F case but the posts on the front panel were a little too wide. I sanded the posts on the front panel down a little and now my front panel is back in place.