JACKCHEN 52CC Gas Powered T Post Driver with carry bag, Air Cooling Single Cylinder 2 Stroke Gasoline Petrol Garden Fencing Tool Machine with 2 Post Driving Head

We got this pile driver hammer to put up the fence for our chickens and the vegetable garden, it works very good and was very impressive that how easy and fast was to drive the pipe into the ground, definitely saved lots of time and hammering…I am very happy with it, it came with everything you need tools and gloves, all you need is just add gas to it… will definitely recommend it.

1 hr in and it broke in half while I was using it. Fell on my foot and bruised me up good. It honestly worked fine until this. But it failed that fast and no returns!! That's crap! Amazon should not deal with companies that don't do anything to back up their products.

Well..shipping was likety split..Easy to apply pounder end...Extra accessories included..If you are a weightlifter...no problem lifting at least 45 lbs. Off the ground and raise to shoulder height ...or a bit higher in my case..Im 5'6"..To place it on a T post...like a frickin Toothpick...I found it easier to ...so I maneuvered a way to lift from slightly above my waist, then lift onto T post. I got them in!

I am at 3400 asl. It does not idle well. The safety and control plastic is brittle and unreliable. To keep it running after hard starts, used masking tape to keep vibration from disabling the on switch. Otherwise for moist non-rocky soils, worked well. For rocky soil, use professional gear. Recommend for healthy adults who can lift the weight repeatedly. Also, you need a helper. To do four foot t posts, any work on a ladder or a tailgate possess fall hazard. Use best safety practices and don't do this alone. Adult supervision required.

Bought to pound some T-Post for a small ridding arena. I pounded 11 8' T-Post and then it snapped at the cast aluminum joint. Amazon will not help at all. They say that I have to talk to the manufacture who is in China. Emailing them to see if they will help.

I don't like 2-stroke engines, however, I started this new cold engine with 3 pulls. I use true fuel for all my 2-stokes. This one is very good. This will need a two person set up. One to operate the driver and the other to hold the pole. We installed 30 "T" posts in a tenth the time with a manual post driver. The hot engine started with 1 or 2 pulls. Always use a fuel that is free of ethical. True Fuel is a good choice.

I needed to put up a fence it made it so easy. My ground is hard and full of rocks and it made it like it was sand. It is hard to put posts in that are 5’ or taller do to how heavy it is but I will order it again

Ive used it for over a year and driven hundreds of t-posts in very hard west Texas soils. It drives t-posts great and is a real arm, shoulder, and back saver! Just give it time and let it do the work for you. I have driven both short and long t-posts, and many of them very deep for deer blind anchor points.HOWEVER; do not attempt to use it with the provided 70mm (2.75") adapter for 2-3/8" diameter steel fence posts! It will flare the top of the post (even 13 gauge) and become almost permanently attached to the post. I drove 1 post in ~3.5' deep. Then I had to unscrew the whole machine from the adapter while it was lodged onto the post, and spent over 4 hours removing the adapter from the post! This adapter is the wrong design for steel posts. It has a spring loaded floor plate that rides in a larger diameter section to allow it to move up and down without falling out, and this is the section that the flared post top gets lodged in.If you are driving steel fence posts you will need a driver with a completely different hammer design. I am going to end up renting one that is design for steel posts.