Class III 2" Towing Hitch Receiver Fit for Ford Bronco 2021-2024, Rear Trailer Hitch, Black

Didn’t have to remove bumper fully. Just removed 2 15mm bolts and lifted it up enough to install the 4 bolts. My 2024 bronco had a bracket with 2 bolts holding it on I had to remove and toss in the garbage to install this.

Easy install and works as it should. Have not tested any heavy loads but seems solid.

This hitch requires the bumper to be removed to install. Bumper is held on with 4x 18mm bolts and 2x 13mm bolts. Two wiring harnesses to disconnect located at both ends of bumper. I did it solo using two stools to support the bumper after sliding it off the vehicle. Be careful plugging the wires back in as the connector gets hung on its o-ring. Hitch installs easily once bumper is removed.

Took a bit of work to bolt in as the bolts go in the opposite direction you would expect. Did have to loosen the bumper to slide the bolts in. However, it does work well.

Great hitch! The directions say you have to remove the bumper but I didn't want to do that with the sensors. I removed the 3 lower bolts on each side and left the bolt at the top on each side in but loosened. I was able to install it by myself and it gave me enough room to get the bolts in. I like that everything is black and there are no separate nuts. The threads are built into the Hitch. Only time will tell if it will rust but so far so good.