Wostore Eccentric Flaring Kit, 7 Dies 3/16-3/4" 45° Heavy Duty HVAC

Very high quality tools (flaring and cutter) easy to use and produces perfect flares. Great buy, bargain price.

Used this kit for HVAC line prep and brake tubing. The dies fit snugly and produced clean 45-degree flares without visible leakage. The cone rolls smoothly and doesn’t scratch the tubing. Instructions were clear enough to follow without guesswork, and the clamp held the pipe securely during use. The cutter worked well on soft metal and PVC. The hard case has a clean layout and keeps the tools organized. The metal parts have a matte finish and look well-machined. For the range of sizes and included tools, it’s a good value for occasional or professional use.

This is a great tool for the money. It took me a minute to figure out how to put it together ( need an instruction sheet ) but once together it worked perfectly. Nice storage case.

When I first looked at this, I thought it was defective. It is a eccentric flairing tool and it works super well. All my HVAC fairs were perfect. Super easy to use and a great tool. A little different from other flair tools but works well and makes perfect flairs...easily!

Got this for my mini split install. Re flared all my fittings on the outdoor unit and used FlareSeal gaskets. I also used SylvrBryt 8 and their flux to braze the indoor unit instead of compression fittings. finally helped my system hold a vacuum. I watched a lot of videos to make sure I was taking the steps to ensure no leaks which is the number one failure of mini splits. You'll find out soon enough.

Well made and did the job

Doesn't work too well with thin Chinese mini split cheap copper lines. I had to wrap the lines with electrical tape multiple times to make it kinda work, keeps pushing the lines out of the clamp. I hope the flares are big enough. Haven't tested them yet.

I purchased this a couple of months back as I had just ordered a new mini split system and needed to shorten the copper line set. The line said I was using was 5/8 by 3/8. For some reason, the 3/8 would not grip in the die so I had to wrap some electrical tape (2x wrapped) around it to grip. Not sure if this was the fault of the line set or the die itself being too large.In any case, I was able to create perfect eccentric, flares, and then just applied some dialogue before I tighten them down with the flare nuts.Overall I was very pleased with this set after I did a couple of test flares and figured out the trick to get it rightPA- Attached is a photo of one of the test flares I did. I did not have the tube inserted far enough, so I ended up with the shallow flare, but as you can see, it is very smooth.

fait le travail

Excellent piece of equipment—I highly recommend it.

Mini spilt install worked well