Brocraft Inflatable Kayak Trolling Motor Mount/SUP Paddle Board Motor Mount/Boat Trolling Motor Mount

nice

I wish this product came with better instructions and the right kind of glue. I ended up using a marine grade glue that worked on PVC but if this came with glue I wouldn't have had to spend so much time figuring out what glue to get. I also would have liked information on placement of the mounts on different kinds of boats. My inflatable kayak made it hard to get the mounts placed evenly because the width of the rubber pads is wider than my kayak gunwales so getting them glued down and holding to the curved surface has been a constant work in progress. At this point I've ended up lashing down the mounts to the hull to prevent them pulling up. I've also added counterbalance weights to the opposite side of the bar from the motor to help prevent the rubber pads from pulling up when I use them.

The attachment pads are hard and to not form well/ at all to the curve of inflatable boat sides. I tried to put them on after heating them with a heat gun to mold and bend them to fit. That did not work. The lips of the pad never conformed. Luckily, I only tried one pad and had to carefully remove it with solvent and pressure. The idea behind this mount is great, but the pads are less so. There were no instruction detailing how to make the pads form on curved surfaces. They would work well on flat attachment surface.

I had this out on my inflatable kayak for four hours trolling a large lake busy with boaters and large wakes. Afterward I found the mounts held up well. No loosening. It’s a bit pricey but I didn’t want any glitches while on the lake. 👍🏼

Works great on my inflatable! I haven't figured out how to turn the rod over yet to allow for trolling motors with longer shafts.

Good product

Great product. I added a steel attachment and 2 rod holders to the transom. Solid .